Allview V4 VIPER PRO User manual

1
V4 VIPER PRO
USER MANUAL…………………………………….............4
MANUAL DE UTILIZARE…………………….…………..19
РЪКОВОДСТВО ЗА УПОТРЕБА………………...........35
UŽIVATELSKÝ MANUÁL….……………………….........51
BETRIEBSANLEITUNG…………………………………..67
MANUAL DE USUARIO ..………………………………...85
HASZNÁLATI UTASÍTÁS ………….........……….........100
INSTRUKCJA OBSŁUGI ...................…………............112

2

3
EN
RO
BG
CZ
1
Power button
1
Buton pornire
1
Бутонът за захранване
1
ON/OFF Tlačítko
2
Speaker
2
Difuzor
2
говорител
2
Reproduktor
3
Micro USB
3
Mufă micro USB
3
Микро USB
3
Micro USB
4
Flash
4
Flash
4
флаш
4
Blesk
5
Volume buttons
5
Butoane volum
5
сила на звука
5
Tlačítka hlasitosti
6
Earphones jack
6
Mufă căști
6
слушалки жак
6
Sluchátka jack
7
Main camera
7
Cameră principală
7
Назад камера
7
Zadní fotoaparát
8
Front camera
8
Cameră frontală
8
Предна камера
8
Přední í fotoaparát
9
10
Proximity and light sensor
Fingerprint sensor
9
10
Senzor de proximitate și
lumină
Senzor de amprentă
9
10
Сензор за близост и
светлина
Пръстови отпечатъци
9
10
Senzor přiblížení a
světla
Senzor otisku prstu
DE
ES
HU
PL
1
Ein- / Ausschalter
1
Botón de encendido
1
Bekapcsoló gomb
1
Przycisk zasilania
2
Redner
2
Altavoz
2
Hangszóró
2
Głośnik
3
Micro USB
3
Micro USB
3
Micro USB
3
Micro USB
4
Blitz
4
Flash
4
Vaku
4
Błyskać
5
Lautstärketasten
5
Volumen
5
Hangerő gombok
5
Przyciski głośności
6
Kopfhörerbuchse
6
Enchufe auriculares
6
Fülhallgató jack
6
Słuchawki jack
7
Hauptkamera
7
Cámara trasera
7
Hátulsó kamera
7
Tylna kamera
8
Vordere Kamera
8
Cámara frontal
8
Elülső kamera
8
Przednia kamera
9
10
Näherungs- und Lichtsensor
Fingerabdruck Sensor
9
10
Sensor de proximidad
y luz
Sensor de huella
digital
9
10
Közeli és fényérzékelő
Ujjlenyomat-érzékelő
9
10
Czujnik zbliżeniowy i
światła
Czujnik odcisków palców

4 EN
Notices for the use of phone
CAUTION! Please readcarefully these instructions and follow them, in thecase of dangeroussituations.
Driving safety: It is recommended not to use the phone while driving. If you use it however, turn on the
Handsfree mode.
Turn off your phone while in an aircraft.
Interference caused by mobile phones affects aviation safety, and thus is illegal to use it on the plane.
Please make sure that your mobile phone is turned off when you are on the plane.
In hospital: When using the phone in a hospital, you must submit to the relevant rules specified by the
hospital. Any interference caused by wireless devices may affect the performance of the phone.
Approved service: Only approved repair shops can repair mobile phones. If you open the phone and try
to fix it yourself you will void the warranty of the product.
Accesories and batteries: Only accesories and batteries approved by the producer can be used.
Emergency calls: Make sure the phone is turned on and enabled if you wish to make an emergency
call. Press the call key and confirm the location, explain what happened and do not close the call.
The battery and charging the battery: It is recommended to fullycharge before the first use of the device.

5 EN
The battery is not removable. Do notpuncture or damage the battery in anyway. Do not expose/keep/store
close to heat sources/in sunlight. Risk of explosion.
Do not expose the battery/product to temperatures above 40C. Do not dispose the battery/product in fire
or drop anywhere. Return defective batteries/products in special centers or to the supplier center.
Warning: We take no responsibility for situations where the phone is used other than as provided in the
manual. Our company reserves the right to make changes in the content of the manual without making this
public. These changes will be posted on the company website to the product it amends.
The contents of this manual may differ from that in the product. In this case, the latter will be considered.
To avoid theproblems that mightoccur with the service shops approved by Visual Fan Ltd. (because Visual
Fan reserves the right to stop the collaboration with any service shop which was previously approved and
mentioned in the waranty card on the date on which the product batch was sold on the market), before
taking a product to the service shop, please check the updated list of approved service shps on Allview
website at the section: “Support&Service – Approved service”.For more product details visit
www.allviewmobile.com.
Do not cover the antenna with your hand or other objects. Failure to comply results in connectivity issues
and rapid discharge of the battery.

6 EN
All applications provided by third parties and installed in this device may be modified and/or stopped at any
moment. Visual Fan Ltd will not be responsible in any way for modifications of the services or content of
these applications. Any request or question regarding third party applications may be addressed to the
owners of these applications.
Due to the used enclosure material, the product shall only be connected to a USB interface of version
2.0 or higher. The connection to the so called power USB is prohibited.
The adapter shall be installed near the equipment and shall be easily accessible.
Do not use the mobile phone in an environment with too high or too low temperature, never expose the
mobile phone under strong sunshine or too a wet environment.
The maximum operating ambient temperature of the equipment is 40℃.
CAUTION! RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE
OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
This device has been tested and meets applicable limits for Radio Frequency (RF) exposure. Specific
Absorption Rate (SAR) refers to the rate at which the body absorbs RF energy. SAR limits are 1.6 Watts
per kilogram (over a volume containing a mass of 1 gram of tissue) in countries that follow the United
States FCC limit and 2.0 W/kg (averaged over 10 grams of tissue) in countries that follow the Council of
the European Union limit. Tests for SAR are conductedusing standard operating positions with the device

7 EN
transmitting at its highest certified power level in all tested frequency bands. To reduce exposure to RF
energy, use a hands-free accessory or other similar option to keep this device away from your head and
body. Carry this device at least 5 mm away from your body to ensure exposure levels remain at or below
the tested levels. Choose belt clips, holsters, or other similar body-worn accessories which do not contain
metallic components, to support operation in this manner. Cases with metal parts may change the RF
performance of the device, including its compliance with RF exposure guidelines, in a manner that has
not been tested or certified, and use of such accessories should be avoided.
For your safety, it is recommended that, during charging, you don’t keep the device near your body, and
that you place it on an inflammable stand. We recommend that, during nighttime, you put the phone
away from you at a minimal distance of 1 meter.
Device power on/off and standby
After inserting the SIM card, memory card and battery (optional), start the phone by holding down the
Power button for 3 seconds. To power off, press and hold the same button and confirm. If you press the
Power button, you will set phone in standby mode. To return shortly, press the same button.
Unlocking, idle screen and applications menu
To unlock the screen when resuming from standby, slide your finger from the bottom to the top of the
screen. The main screen will be displayed.

8 EN
Home screen pages can be customized with shortcuts and widgets. At the top of the screen there is the
notification bar that contains information about the mobile network signal, WiFi, Bluetooth, battery level,
time and events.
To display the applications menu, touch the Menu icon from the bottom of the main screen. Slide the
screen up to scroll through the main menu. Touch the desired application icon to access it. Use the
Back button to return to the main screen.
Dialing
To call a number, from the main screen, open the dialer, dial the number and press the call key.
To answer a call, drag the icon to the right, and to reject the call drag the icon to theleft.
You can call numbers directly from Call log, touch the dial symbol from the right side of the desired
number.
Messaging
To create and send an SMS, proceed as follows:
- Open the applications menu;
- Open the Messaging application;
- From the bottom-right side of the screen touch Compose new message symbol;
- Write the message;

9 EN
Note: You create an MMS by touching the “+” symbol and adding media content: images, sound or
movies.
- In the top text box add the number or the name of the recipient;
- Tap the arrow -> symbol from the right side of the text box to send the message.
Contacts
Access the Contacts from menu applications.
Add new contact:
- Open Contacts from main menu;
- Tap the + symbol from the bottom-right side of the screen;
- Select the memory where you will store: account or phone entry;
- Enter contact information;
- Finally, tap Save.
Add new contact from call log:
- From the applications menu, open the Dialer;
- Tap the phone number you want to save;
- Tap New contact button;
- Select the memory where you will store: account or phone entry;

10 EN
- Enter contact information;
- Finally, tap Save.
Import/export contacts
You can import or export contacts between memories and accounts available, as follows:
- Open Contacts;
- Press the Options button and select Import/Export;
- Choose a memory from which to copy contacts;
- Choose in which memory to copy the contacts;
- Select contacts to copy;
- Press the Copy button;
Synchronize contacts with an account
Note: If you don’t have an account, you can create one which is also necessary for Google Play.
You can synchronize the contacts of an account by following the next steps:
- Open the applications menu -> Settings -> Applications -> ACCOUNTS;
- Touch the desired account; if you don’t have one already set, you can add a new one by touching the
button Add new account;
- Tick the option Sync contact;