Allview V5 Viper User manual

V5 Viper
USER MANUAL…………………………………….............4
MANUAL DE UTILIZARE…………………….…………..17
РЪКОВОДСТВО ЗА УПОТРЕБА………………...........29
KASUTUSJUHEND ………...……………………….........42
HASZNÁLATI UTASÍTÁS …...…………………….……..54
VARTOTOJO VADOVAS ..…….………………………....62
LIETOTĀJA ROKASGRĀMATA ..…………...................76
INSTRUKCJA OBSŁUGI ........................…....................89

2

3
EN
RO
BG
EST
1
Power button
1
Buton pornire
1
Бутонът за захранване
1
Toitenupp
2
Speaker
2
Difuzor
2
говорител
2
Kõneleja
3
Micro USB
3
Mufă micro USB
3
Mikro USB
3
Micro USB
4
Flash
4
Flash
4
флаш
4
Välk
5
Volume buttons
5
Butoane volum
5
сила на звука
5
Helitugevuse nupud
6
Earphones jack
6
Mufă căști
6
слушалки жак
6
Kõrvaklappide pesa
7
Main cameras
7
Camere principale
7
Назад камери
7
Põhikaamera
8
Front camera
8
Cameră frontală
8
Предна камера
8
Esikaamera
9
10
11
Proximity and light sensor
Fingerprint sensor
Microphone
9
10
11
Senzor proxim. și lumină
Senzor de amprentă
Microfon
9
10
11
Сензор за близост и
светлина
Пръстови отпечатъци
Микрофон
9
10
11
Läheduse ja valguse andur
Sõrmejäljeandur
Mikrofon
HU
LT
LV
PL
1
Bekapcsoló gomb
1
Įjungimo mygtukas
1
Ieslēgšanas poga
1
Przycisk zasilania
2
Hangszóró
2
Garsiakalbis
2
Runātājs
2
Głośnik
3
Mikro USB
3
Mikro USB
3
Micro USB
3
Mikro USB
4
Vaku
4
Blykstė
4
Flash
4
Błyskać
5
Hangerő gombok
5
Garso mygtukai
5
Skaļuma pogas
5
Przyciski głośności
6
Fülhallgató jack
6
Ausinių kištukas
6
Austiņu ligzda
6
Słuchawki jack
7
Hátsó kamerák
7
Pagrindinė kamera
7
Galvenā kamera
7
Tylne kamery
8
Elülső kamera
8
Priekinė kamera
8
Priekšējā kamera
8
Przednia kamera
9
10
11
Közeli és fényérzékelő
Ujjlenyomat-érzékelő
Mikrofon
9
10
11
Artumo ir šviesos
jutiklis
Pirštų atspaudų jutiklis
Mikrofonas
9
10
11
Tuvuma un gaismas
sensors
Pirkstu nospiedumu sensors
Mikrofons
9
10
11
Czujnik zbliżeniowy i
światła
Czujnik odcisków palców
Mikrofon

4 EN
Notices for the use of phone
CAUTION! Please read carefully these instructions and follow them, in the case of dangerous
situations.
Driving safety: It is recommended not to use the phone while driving. If you use it however, turn on the
Handsfree mode.
Turn off your phone while in an aircraft.
Interference caused by mobile phones affects aviation safety, and thus is illegal to use it on the plane.
Please make sure that your mobile phone is turned off when you are on the plane.
In hospital: When using the phone in a hospital, you must submit to the relevant rules specified by the
hospital. Any interference caused by wireless devices may affect the performance of the phone.
Approved service: Only approved repair shops can repair mobile phones. If you open the phone and
try to fix it yourself, you will void the warranty of the product.
Accesories and batteries: Only accesories and batteries approved by the producer can be used. It is
recommended that the phone is kept at a minimum of 25mm away from any body part.
Emergency calls: Make sure the phone is turned on and enabled if you wish to make an emergency
call. Press the call key and confirm the location, explain what happened and do not close the call.
The battery and charging the battery: It is recommended to fully charge before the first use of the
device.

5 EN
The battery is not removable. Do not puncture or damage the battery in any way. Do not
expose/keep/store close to heat sources/in sunlight. Risk of explosion.
Do not expose the battery/product to temperatures above 40C. Do not dispose the battery/product in
fire or drop anywhere. Return defective batteries/products in special centers or to the supplier center.
Warning: We take no responsibility for situations where the phone is used other than as provided in the
manual. Our company reserves the right to make changes in the content of the manual without making
this public. These changes will be posted on the company website to the product it amends. Also, we are
not responsible for any printing errors. The contents of this manual may differ from that in the product. In
this case, the latter will be considered.
To avoid the problems that might occur with the service shops approved by Visual Fan Ltd. (because
Visual Fan reserves the right to stop the collaboration with any service shop which was previously
approved and mentioned in the waranty card on the date on which the product batch was sold on the
market), before taking a product to the service shop, please check the updated list of approved service
shps on Allview website at the section: “Support&Service – Approved service”.For more product details
visit www.allviewmobile.com.
Do not cover the antenna with your hand or other objects. Failure to comply results in connectivity issues
and rapid discharge of the battery.

6 EN
All applications provided by third parties and installed in this device may be modified and/or stopped at
any moment. Visual Fan Ltd will not be responsible in any way for modifications of the services or
content of these applications. Any request or question regarding third party applications may be
addressed to the owners of these applications.
Due to the used enclosure material, the product shall only be connected to a USB interface of version
2.0 or higher. The connection to the so called power USB is prohibited.
The adapter shall be installed near the equipment and shall be easily accessible.
Do not use the mobile phone in an environment with too high or too low temperature, never expose
the mobile phone under strong sunshine or too a wet environment.
The maximum operating ambient temperature of the equipment is 40℃.
CAUTION! RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
This device has been tested and meets applicable limits for Radio Frequency (RF) exposure. Specific
Absorption Rate (SAR) refers to the rate at which the body absorbs RF energy. SAR limits are 1.6 Watts
per kilogram (over a volume containing a mass of 1 gram of tissue) in countries that follow the United
States FCC limit and 2.0 W/kg (averaged over 10 grams of tissue) in countries that follow the Council of
the European Union limit. Tests for SAR are conducted using standard operating positions with the

7 EN
device transmitting at its highest certified power level in all tested frequency bands. To reduce exposure
to RF energy, use a hands-free accessory or other similar option to keep this device away from your
head and body. Carry this device at least 25 mm away from your body to ensure exposure levels remain
at or below the tested levels. Choose belt clips, holsters, or other similar body-worn accessories which
do not contain metallic components, to support operation in this manner. Cases with metal parts may
change the RF performance of the device, including its compliance with RF exposure guidelines, in a
manner that has not been tested or certified, and use of such accessories should be avoided.
For your safety, it is recommended that, during charging, you don’t keep the device near your body,
and that you place it on an inflammable stand. We recommend that, during nighttime, you put the
phone away from you at a minimal distance of 1 meter.
Device power on/off and standby
After inserting the SIM card, memory card and battery (optional), start the phone by holding down the
Power button for 3 seconds. To power off, press and hold the same button and confirm. If you press
the Power button, you will set phone in standby mode. To return, shortly press the same button.
Unlocking, idle screen and applications menu
To unlock the screen when resuming from standby, slide your finger from the bottom to the top of the
screen. The main screen will be displayed.

8 EN
Home screen pages can be customized with shortcuts and widgets. At the top of the screen there is
the notification bar that contains information about the mobile network signal, WiFi, Bluetooth, battery
level, time and events.
To display the applications menu, touch the Menu icon from the bottom of the main screen. Slide the
screen up to scroll through the main menu. Touch the desired application icon to access it. Use the
Back button to return to the main screen.
Dialing
To call a number, from the main screen, open the dialer, dial the number and press the call key.
To answer a call, drag the icon to the right, and to reject the call drag the icon to the left.
You can call numbers directly from Call log, touch the dial symbol from the right side of the desired
number.
Messaging
To create and send an SMS, proceed as follows:
- Open the applications menu;
- Open the Messaging application;
- From the bottom-right side of the screen touch Compose new message symbol;
- Write the message;

9 EN
Note: You create an MMS by touching the “+” symbol and adding media content: images, sound or
movies.
- In the top text box add the number or the name of the recipient;
- Tap the arrow -> symbol from the right side of the text box to send the message.
Contacts
Access the Contacts from menu applications.
Add new contact:
- Open Contacts from main menu;
- Tap the + symbol from the bottom-right side of the screen;
- Select the memory where you will store: account or phone entry;
- Enter contact information;
- Finally, tap Save.
Add new contact from call log:
- From the applications menu, open the Dialer;
- Tap the phone number you want to save;
- Tap New contact button;
- Select the memory where you will store: account or phone entry;

10 EN
- Enter contact information;
- Finally, tap Save.
Import/export contacts
You can import or export contacts between memories and accounts available, as follows:
- Open Contacts;
- Press the Options button and select Import/Export;
- Choose a memory from which to copy contacts;
- Choose in which memory to copy the contacts;
- Select contacts to copy;
- Press the Copy button;
Synchronize contacts with an account
Note: If you don’t have an account, you can create one which is also necessary for Google Play.
You can synchronize the contacts of an account by following the next steps:
- Open the applications menu -> Settings -> Applications -> ACCOUNTS;
- Touch the desired account; if you don’t have one already set, you can add a new one by touching
the button Add new account;
- Tick the option Sync contact;