Connect the power cable to the printer
power cable port.
Charge the printer battery as required.
Open the printer paper cover.
If necessary, remove the remaining
core of the old paper roll.
Install the new paper roll as shown.
Align the paper correctly.
Pull the paper out and close the paper
cover.
Press the FEED button to make sure
the paper feeds correctly
Battery Removal and Replacement
Removal: Push the battery clip down
and move the battery away from the
printer casing as shown.
Remove the battery from the printer
casing.
Replacement: Install the battery in the
printer casing.
Push the battery into position in the
printer casing. A clicking sound
indicates the battery is installed
correctly.
Make sure the power cable
end is orientated correctly to
the printer power port before
connecting
The USB connection is not
operational and cannot be
used with the SADPmini2
Low Power Alarm and Auto Sleeping
Dimension 106.5(L) x78(W) x 47(H) mm
Weight 190 g (excluding roll paper)
Operating Temp 0 °C - +40 °C
Storage Temp -20 °C - +60 °C
Operating Humidity < 95%RH
Part No. BTP01-PRINTER
DC7.4 V, 1.5 A rechargeable Li-ion battery 1500 mAh
Battery charged fully charged in 2 hours with a standby time over 15 days.
Part No. BTP01-BATTERY
If battery charge is low during printing, the power indicator will turn Red to show that there is still
data to be printed. If there is no data to print, the printer will move into a low power sleep mode
after in 2 seconds. It will awaken if FEED button is pressed or data is sent to it.
Type Thermal Paper
Width 58 mm
Thickness 60-80 μm
Roll Diameter Maximum 40 mm
Part No. BTP01-PAPER
Model ABT015084
AC Voltage Input Range 90-260 Vac
Input Frequency Range 50 or 60 Hz
Rated Working Output DC Voltage 5.4-8.0 V
Rated Working Output DC Current 1.35-1.65 A
Charging condition from red light to green light 0.08 A < I <0.2 A or Vout > 8.45 V
Features over-current and short circuit protection.
Part No. BTP01-CHARGER
