ALTEAM RFD-970W User manual

Headphone Manual:
1、Hold the ”ON/OFF” approx. 3 seconds to turn on the headphone. The light will turn to
red and flash. On the contrary, hold the on/off approx 3 seconds, turn off the power.
2、Use the USB cable (14) and connect a computer to the transmitter (8); switch theAudio
Select (13) in the down side, and the LED light(7) of transmitter will flash.
3、Hold the “Scan” button of headphone (2) and transmitter (11) for approx. 3 seconds at
the same time. The headphone will have “toot toot toot…” sound, then, release the
buttons. The headphone and transmitter has ready to pair up. Once you pair up, you don’t
need to pair it again.
4、When play music, the headphone LED will go red (3), so as the transmitter LED (7).
5、If you want to pause music, hold the RF ON/OFF button (12) approx 1 second; If you
want to continue music, hold the RF ON/OFF button again

6、Connect the 3.5mm plug (10) to the mp3 player, and switch the Audio Select (13) in up
side. Connect the transmitter, the USB cable (14) and the supplied AC 5V power adapter
(15).
The LED light of transmitter will flash.
7、One transmitter can receive several headphones’ signal
8、There is a recharged plug for headphone on the backside of transmitter (9).
Plug it into the hole on the left side of the headphone.
9、When there is no signal in 10 minutes, headphone will turn off automatically.
10、When the battery power is low, headphone will have noise sound, its reminding user
to change the battery. If not, headphone will turn off automatically within 5 minutes.
11、Headphone can be used for 8 hours.
12、Two Re-chargeable AAANI-MH Batteries required. When recharging is going on, the
LED will flash blue, once the charge is completed, the LED light goes out.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one of the following
measures:
. Reorient or relocate the receiving antenna.
. Increase the separation between the equipment and receiver.
. Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
. Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: To assure continued compliance, any changes or modifications not expressly approved
by the party responsible for compliance could void the user's authority to operate this equipment.
(Example - use only shielded interface cables when connecting to computer or peripheral devices).
FCC Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of 20
centimeters between the radiator and your body.

This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
The antennas used for this transmitter must be installed to provide a separation distance of at least 20
cm from all persons and must not be co-located or operating in conjunction with any other antenna or
transmitter.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause undesired operation.