Altec Lansing MZX008 User manual

MZX008
In the Box
A Closer Look
Controlling
Music
Charging
Powering On/
Bluetooth
Pairing
QUICK START GUIDE
USB Cable
MZX008 Bluetooth
On Ear Headphones
1-2 Hours
Full Charge
(red) = Charging
Complete
2-3 SEC Pairing Mode
Red & Blue Flashing LED
Paired
Blue Slowly Flashing LED
MZX008 -
+
PRESS
PRESS
Phone Calls/
JUST ASK
For additional user materials and warranty information,
please visit us at www.alteclansing.com
Aux In
Micro USB Port Charging Indicator
Bluetooth Indicator
Answer Call
End Call
X
PRESS & HOLD (2sec)
Reject Incoming Call
PRESS
PRESS x2
Activate Siri or
Google Assistant
Power/Play/Pause
Microphone
Volume Up/
Next Track
Volume Down/
Previous Track
PRESS & HOLD
PRESS & HOLD
PRESS PRESS & HOLD
Overall battery performance varies dependent upon
use,settings and environmental conditions.For
further information,please visit www.
alteclansing.com
The Bluetooth® wordmark and
logos are registeredtrademarks
owned by the Bluetooth SIG, Inc.
and any use of such marks by Sakar
International is under license. Other
trademarks and trade names are
those of their respective owners.

FCC Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation .
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates. uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television
reception , which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following
measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
--Consult the dealer or an experienced radio / TV technician for help.