Altelix NS242416VFA1C-R6U User manual

Altelix LLC USA: 866-660-WIFI (9434) International: [phone] [email protected] www.altelix.com
Copyright (C) 2017 Altelix LLC. All rights reserved. Altelix and the Altelix logo are Trademarks and/or Registered Trademarks of Altelix LLC.
Specifications are subject to change without notice. See www.altelix.com for most current information
IS0142 Rev A 10/10/19
NS242416VFA1C-R6U Enclosure
Installation Guide
Step 1:
Remove the blank access panel located on the
bottom of the enclosure.
WARNING: READ ALL INSTRUCTION BEFORE USE. THIS ENCLOSURE IS DESIGNED TO BE
INSTALLED BY A TRAINED PROFESSIONAL INSTALLER.
Access Panel
Step 2:
Position the included gasket onto the Power/Fan
module as shown. For proper seal, ensure the
holes in gasket are aligned with mounting holes in
module panel.
Step 3:
Secure Power/Fan module to
enclosure using supplied hardware.
To ensure proper seal, use the nylon
washers included with hardware. Mounting Screw
with Nylon Washer
Mounting:
For wall mounting (4) 5/16”
(8mm) diameter holes are
provided on the rear of the
enclosure.
Enclosure with
Power/Fan Module Installed
Mounting Holes
For pole mounting, optional
NMKS-S Series pole mount
kits are available from
Altelix.
Power/Fan Module
with Gasket

Altelix LLC USA: 866-660-WIFI (9434) International: [phone] [email protected] www.altelix.com
Copyright (C) 2017 Altelix LLC. All rights reserved. Altelix and the Altelix logo are Trademarks and/or Registered Trademarks of Altelix LLC.
Specifications are subject to change without notice. See www.altelix.com for most current information
IS0142 Rev A 10/10/19
19” Equipment Rack
Step 1:
Open side panels as shown.
Step 2:
Unscrew the (4) M4 screws on each side panel and slide panels to desired depth. Secure
each side panel with (4) M4 screws.
Note:
19” 6U bracket can hold up to 40 lbs. evenly distributed.
NS242416VFA1C-R6U Enclosure
Installation Guide

Altelix LLC USA: 866-660-WIFI (9434) International: [phone] [email protected] www.altelix.com
Copyright (C) 2017 Altelix LLC. All rights reserved. Altelix and the Altelix logo are Trademarks and/or Registered Trademarks of Altelix LLC.
Specifications are subject to change without notice. See www.altelix.com for most current information
IS0142 Rev A 10/10/19
WARNING: INSTALLATION OF THIS PRODUCT NEAR POWERLINES IS DANGEROUS.
FOR YOUR SAFETY, FOLLOW THE INSTALLATION DIRECTIONS
Under some conditions, this enclosure may not prevent electrocution. Users should keep enclosure away from
any overhead wires. If enclosure contacts a power line, any initial protection could fail at any time. IF ENCLOSURE
NEARS ANY OVERHEAD WIRES, IMMEDIATELY LET GO, STAY AWAY, AND CALL UTILITY COMPANY
THIS ENCLOSURE IS DESIGNED TO BE INSTALLED ONLY BY A TRAINED PROFESSIONAL
INSTALLER
Warning: To avoid electric shock, grounding must be installed by the installer as part of the installation. The unit
must be grounded and installed in accordance with National Electrical Codes (NEC) and any local codes. Note that
non-metallic enclosures do not provide grounding between conduit connections.
Warning: Enclosure must be secured using a pad-lock when energized to prevent unauthorized access and shock
hazard.
Important: Look over the site before beginning installation, and anticipate possible hazards.
Select a safe site to install the enclosure.
If you have power lines in the area, call your local electric utility for assistance.
NEVER work alone; always have someone near who can summon help.
Check weather conditions. Be sure that the area is not slippery and make sure that rain or thunderstorms are not
predicted for the day you install the enclosure.
If you need to use a ladder, make sure it is made of non-conductive (non-metallic) material.
Enclosures improperly installed or installed to an inadequate structure are susceptible to wind damage
that can be very serious or even life threatening. Ensure that the installation is properly grounded.
Ensure that the enclosure is properly secured and structurally sound to support all loads (weight, wind &
ice).
Rooftop Installation Warning
DO NOT assume that just because you're on a roof, you're isolated from
ground. You may still be electrocuted or fall off the roof.
NS242416VFA1C-R6U Enclosure
Installation Guide