Altronics A1018B User manual

A1018B –OUTDOOR RECEIVER KIT (REMOTE SWITCH UHF 12/24Vd.c.)
Features:
1. 2 Channels (A & B) independently set-up.
2. Buttons have slide protector to prevent accidental
activation.
3. Can learn over 100 transmitter codes
4. Hopping (Rolling) Code technology –Provides a
secure encrypted radio frequency (RF) transmission.
Learning Mode: Programming:
NOTE: The radio control units included in the pack are
already programmed and ready to use.
See the above diagram to find the correct buttons to
press.
Press the P1 as instructed below to enter different
modes:
ONE time to program R1 in monostable mode - LED
flashes one time and stays alight, then press the button
that you want the unit to learn, until the LED goes off.
Channel R1 has successfully learned the code. The
control mode of relay is non-locking (state A).
TWO times to program R2 in monostable mode - LED
flashes two times and stays alight, then press the button
that you want the unit to learn, until the LED goes off.
Channel R2 has successfully learned the code. The
control mode of relay is non-locking (state B).
THREE times to program R1 in bistable mode - LED flash
three times and stays alight, then press the button that
you want the unit to learn, until the LED goes off.
Channel R1 has successfully learned the code. The
control mode of relay is interlocking (state C).
FOUR times to program R2 in bistable mode - LED flash
four times and stays alight, then press the button that
you want the unit to learn, until the LED goes off.
Channel R2 has successfully learned the code. The
control mode of relay is interlocking (state D).
Note: If you press P1 many times, the state D will
deactivate. Hold down the key of the radio remote
control that you would like to acquire until the led
blinks.
Deleting Programmed Codes:
There are two ways of deleting saved codes:
1. Deleting a single code -Press P2 button for about
two seconds and release. The LED will light up.

A1018B –OUTDOOR RECEIVER KIT (REMOTE SWITCH UHF 12/24Vd.c.)
Then press the key on the radio remote control that
you want to delete.
2. Deleting all codes acquired (Reset unit) - Press P2
button until the LED turns on (about 8 seconds) and
then release. Repeat the learning process.
Technical Parameters:
Power Supply
9V - 24V AC / DC
Frequency
433.92 MHz
Max Consumption
200 mA
Decoding
Binary
No. of Max Codes
140
No. of Channels
2
No. of Outputs
NO / NC 2
Max Switching Power
0.5 A / 120 VA
Operating Temperature
-20/ + 50 ℃
Working Distance
100 meters
Relay Spec
12A 14V DC or 7A 120V AC
Notes for Installation:
WARNING! It is important the following manual should
be followed for safety reasons. Store the instructions
for future reference. Anything not expressly envisaged
in these instructions is not permitted.
The packaging materials should be kept out of the reach
of children since they are potentially hazardous.
The product must only be installed by a qualified
installer. Incorrect installation or improper use of the
product can lead to severe damage to property and / or
persons.
The manufacturer declines all responsibility resulting
from improper use of device. Do not modify the device
in any way.
Disconnect the power supply prior to any intervention
on the system. The status of the system has a direct
influence on the reliability and safety of the device.
WWW.ALTRONICS.COM.AU