Altronix ALTV615DC44ULM User manual

Rev. 050404
ALTV615DCUL Series
CCTV Power Supplies
Installation Guide
Models Include:
•ALTV615DC44ULM •ALTV615DC44ULCBM
- 6-15VDC @ 4 amp - 6-15VDC @ 4 amp
- Four (4) Fuse Protected Outputs. - Four (4) PTC Protected Outputs.
•ALTV615DC48ULM •ALTV615DC48ULCBM
-6-15VDC @ 4 amp - 6-15VDC @ 4 amp
- Eight (8) Fuse Protected Outputs. - Eight (8) PTC Protected Outputs.
•ALTV615DC416UL •ALTV615DC416ULCB
- 6-15VDC @ 4 amp - 6-15VDC @ 4 amp
- Sixteen (16) Fuse Protected Outputs. - Sixteen (16) PTC Protected Outputs.
•ALTV615DC616UL •ALTV615DC616ULCB
- 6-15VDC @ 6 amp - 6-15VDC @ 6 amp
- Sixteen (16) Fuse Protected Outputs. - Sixteen (16) PTC Protected Outputs.
•ALTV615DC416ULCBM*
- 6-15VDC @ 4 amp
- Sixteen (16) PTC Protected Outputs.
* Same except for enclosure size
For models with line cord installed : For 3-wire add suffix “3” e.g. ALTV615DC44ULM3.

Overview:
These Altronix DC CCTV Power Supplies provide 6-15VDC distributed via fuse or PTC protected outputs for powering
CCTV Cameras, heaters and other video accessories.
ALTV615DCUL Reference Chart:
ALTV615DC44ULM 4 amp 6-15VDC 4 - x x 3.5 amp 0.9 amp
ALTV615DC44ULCBM 4 amp 6-15VDC 4 x x - 2.5 amp 0.9 amp
ALTV615DC48ULM 4 amp 6-15VDC 8 - x x 3.5 amp 0.9 amp
ALTV615DC48ULCBM 4 amp 6-15VDC 8 x x - 2.5 amp 0.9 amp
ALTV615DC416UL 4 amp 6-15VDC 16 - x x 3.5 amp 0.9 amp
ALTV615DC416ULCB 4 amp 6-15VDC 16 x x - 2.5 amp 0.9 amp
ALTV615DC616UL 6 amp 6-15VDC 16 - - x 3.5 amp 1.5 amp
ALTV615DC616ULCB 6 amp 6-15VDC 16 x x - 2.5 amp 1.5 amp
ALTV615DC416ULCBM* 4 amp 6-15VDC 16 x x - 2.5 amp 0.9 amp
*Same except for enclosure size.
Specifications:
Caution: This installation should be made by qualified service personnel and should conform to all local
codes and in accordance with the National Electrical Code.
Installation Instructions:
1. Mount unit in desired location.
2. Remove Power Distribution Module and isolation barrier (models with “M” suffix only).
3. Connect AC power to the two black and two white flying leads of the transformer (Figs. 1-4, pgs. 4-6).
Units with linecord installed skip Instruction #3.
Use 18 AWG or larger for all power connections. Connect green ground lead to earth ground (Fig. 1-4, pgs. 4-6).
Keep power limited wiring separate from non-power limited wiring. Minimum .25” spacing must be provided.
Use separate knockouts.
4. Adjust output voltage (unit is factory set at 12VDC): use the trimpot on the power supply board
prior to connecting CCTV devices.
5. Measure output voltage before connecting devices. This helps avoid potential damage.
CAUTION: Determine the maximum operating voltage of the equipment being powered before adjusting the
output voltage.
6. Reinstall isolation barrier and Power Distribution Module (models with “M” suffix only).
Altronix
Model Number
Output Current
(max per output)
Total Output Current
(Power)
Output Voltage
115VAC
50/60Hz Input
Current
PTC Protected
Outputs
Fuse Protected
Outputs
- 2 -
Number of
Outputs
Class 2 Rated
Power Limited
• UL Listed for Commercial CCTV Equipment (UL 2044).
CUL Listed - CSA Standard C22.2 No.1-98, Audio,
Video and Similar Equipment.
• Four (4), eight (8), or sixteen (16) individual outputs.
• Filtered and electronically regulated outputs.
• Short circuit and thermal overload protection.
• Unit maintains camera synchronization.
• Ease of installation saves time & eliminates costly labor.
• Spare fuses included (on fuse protected models).
Enclosure Dimensions:
ALTV615DC44ULM, ALTV615DC44ULCBM,
ALTV615DC48ULM, ALTV615DC48ULCBM, and
ALTV615DC416ULCBM: 8.5”H x 7.5”W x 3.75”D
All other models: 13”H x 13.5”W x 3.25”D

7. Connect devices to terminals marked [1P - 1N through 4P - 4N] on PD4/PD4CB board,
[1P - 1N through 8P - 8N] on PD8/PD8CB, [1P - 1N through 16P - 16N] on PD16W/PD16WCB/PD16CB board,
carefully observing correct polarity (Figs. 1-4, pgs. 4-6).
Terminals marked [1P - 16P] are positive (+) and terminals marked [1N - 16N] are negative.
8. Green LED will illuminate when unit is powered.
9. Upon completion of wiring, secure enclosure door with screws (supplied).
WARNING: To reduce the risk of fire or electric shock, do not expose the unit to rain or moisture.
Terminal Identification:
Power Supply Board
Terminal Legend Function/Description
AC/AC Low voltage AC input.
+ DC -- 6VDC-15VDC output.
PD4UL/PD4ULCB - Distribution Module
1P - 4P Positive DC outputs.
1N - 4N Negative DC outputs.
PD8UL/PD8ULCB - Distribution Module
1P - 8P Positive DC outputs.
1N - 8N Negative DC outputs.
PD16W/PD16WCB/PD16CB - Distribution Module
1P - 16P Positive DC outputs.
1N - 16N Negative DC outputs.
The lightning flash with arrow head symbol within an equilateral triangle is intended to alert the user to the
presence of an insulated “DANGEROUS VOLTAGE” within the products enclosure that may be of sufficient
magnitude to constitute an electric shock.
The exclamation point within an equilateral triangle is intended to alert the user to the presence of important
operating and maintenance (servicing) instructions in the literature accompanying the appliance.
CAUTION: To reduce the risk of electric shock do not open enclosure. There are
no user serviceable parts inside. Refer servicing to qualified service personnel.
- 3 -

CAUTION: De-energize unit prior to servicing. For continued protection against fire hazard
replace fuse with the same type and rating 3.5A, 250V. Do not expose unit to rain or moisture.
Black
Lead
White
Lead
115VAC input
50/60 Hz
XFMR
ALTRONIX CORP.
BKLYN ., NY 11220
AC AC
Power
Supply
Board
Trimpot
Used on PTC Models
(example: ALTV615DC44UCBM)
Power Limited
Class 2
F1 F2 F3 F4
INPUT
1P 1N 2P 2N 3P 3N 4P 4N
LED
1P, 2P, 3P,4P= FUSED OUTPUTS 1N, 2N, 3N, 4N = COMMON OUTPUTS
MAIN FUSE
Output Wiring
Green Lead
(ground)
Barrier
INPUT
1P 1N 2P 2N 3P 3N 4P 4N
LED
1P, 2P, 3P, 4P = FUSED OUTPUTS
1N, 2N, 3N, 4N = COMMON OUTPUTS
3.5A 250V
3.5A 250V 3.5A 250V
MAIN FUSE
ON OFF ON OFF
Fig. 1
ALTV615DC44ULM • ALTV615DC44ULCBM
Black
Lead
White
Lead
115VAC input
50/60 Hz
XFMR
ALTRONIX CORP.
BKLYN ., NY 11220
+ DC -- AC AC
Power
Supply
Board
Trimpot
Green Lead
(ground)
Used on PTC Models
(example: ALTV615DC48UCBM)
Power Limited
Class 2
SW1
ON OFF
CAUTION: De-energize unit prior to servicing. For continued protection against fire hazard
replace fuse with the same type and rating 3.5A, 250V. Do not expose unit to rain or moisture.
Output Wiring
Barrier
SW1
ON OFF
Fig. 2
ALTV615DC48ULM • ALTV615DC48ULCBM
- 4 -

Door
CAUTION: De-energize unit prior to servicing. For continued protection against fire hazard
replace fuse with the same type and rating 3.5A, 250V. D o not expose unit to rain or moisture.
3.5A 250V
For continuous protection against
risk of fire replace fuses with
same type and rating.
common
outputs
protected
outputs
P
N
NPS
XFMR Input
PD16W
12345678 9 10 11 12 13 14 15 16
N
P
Wire Strap
(from
Enclosure
to Door)
non-
power
limited
XFMR XFMR
Black Lead
White Lead
115VA C input
50/60 Hz
Power Supply
Board
Used on PTC Models
(example: ALTV615DC416CB)
P
N
PTC's
NPS
XFMRInput
Power Limited Class 2
PD16W
common
outputs
protected
outputs
12345678
9 10 11 12 13 14 15 16
PN
DC outputs
DC outputs
Green
Lead
(ground)
Power
Switch
- 5 -
Fig. 3
ALTV615DC416UL • ALTV615DC416ULCB • ALTV615DC616UL • ALTV615DC616ULCB

Black
Lead
White
Lead
115VAC input
50/60 Hz
XFMR
Power
Supply
Board
Trimpot
DC Outputs
Class 2 Power Limited
Output Wiring
CAUTION: De-energize unit prior to servicing. Do not expose unit to rain or moisture.
Green Lead
(ground)
Barrier
- 6 -
Fig. 4
ALTV615DC416ULCBM

5.10"
6.5625"
3.25"3.25"
5.10"
5.10"
3.25"
1.00"10.50"1.00"
1.00" 1.00"
1.40"
1.20"
1.40"
1.20"
0.75"0.75" 11.00"
12.50"
3.25"
0.9375"
0.9375"
1.40" 4.85" 4.85" 1.40"
1.20"
Bottom
Top
RightLeft
- 7 -
Enclosure Dimensions for:
• ALTV615DC44ULM
• ALTV615DC44ULCBM
• ALTV615DC48ULM
• ALTV615DC48ULCBM
• ALTV615DC416ULCBM
8.5"H x 7.5"W x 3.5"D
Enclosure Dimensions for:
• ALTV615DC416UL
• ALTV615DC416ULCB
• ALTV615DC616UL
• ALTV615DC616ULCB
13"H x 13.5"W x 3.25"D

Altronix Corp.
140 58th Street, Brooklyn, New York 11220 USA, 718-567-8181, fax: [phone]
web site: www.altronix.com, e-mail: [email protected], Lifetime Warranty, Made in U.S.A.
II1ALTV615DCULSeries I14F MEMBER
Altronix is not responsible for any typographical errors.
- 8 -
Notes: