1
We reserve the right to any technical change. Valid on 2019.09.18
1. TECHNICAL SPECIFICATIONS
OPERATING MANUAL FOR UNDER PLASTER SWITCH WITH RADIO RECEIVER DC1690
STOP
433 MHz AC
230V / 50Hz
- single channel control
BASE
TOP
Power supply: ~230V/50Hz
Applied for max 50 Nm tubular motor
Frequency: 433.92 Mhz
Can store 20 channels at most
Radiated power: 10 miliwat (mW)
- Operating temperature: ~ -10°C ~ +55°C
- Average range: 200 meters (in open space)
35 meters (inside buildings)
- Dimensions: 80x80 mm
Works with standard version tubular motors and can match all DC remote
controllers
The switch is designed for use in dry rooms and should not be exposed to direct
weather conditions.
Installation of the switch should be carried out by authorized persons
(e.g. ECS authorisations to operate electrical devices up to 1 kV).
NOTE
The switch should be powered by a separate circuit and protected by a quick
fuse for example: circuit breaker type B10.
Company reserves the tolerance of catalog data due the different conditions
usage.
2. ELECTRICAL CONNECTIONS BETWEEN MOTOR AND UNDER PLASTER SWICH
Power supply: 230V / 50 Hz Wiring diagram
In accordance with the provisions of the Directive of the European Parliament and of the Council 2012/19 / EU of 4 July 2012 on waste electrical
and electronic equipment (WEEE), it is prohibited to place of used equipment together with other wastes, marked with crossed out wheeled bin
symbol. The users are obliged to transfer their used equipment to a designated collection point for proper processing. The marking means, at the
same time, that the equipment was put on the market after 13 August 2005. These legal obligations have been introduced to reduce the amount
of waste generated from waste electrical and electronic equipment and to ensure an appropriate level of collection, recovery and recycling.
The equipment does not contain any dangerous components, which would have any particularly negative impact on the environment and human
health.
