Alvin Olympian CH300-40 User manual

Olympian Chair (Office Height)
Assembly Instructions For model
CH300-40
Parts Included:
Tools Required: Allen wrench Important: Keep screws loosely tightened during the assembly process.
Tighten them fully once chair is assembled or when instructed.
4Place the back rest (E) face up on a clean, flat surface with
the attached brackets facing up. See Figure 2.
5Position the seat (F) so that the holes are lined up with the
holes on the back rest brackets.
6Use three metal bracket screws (G) in the middle 3-hole
metal bracket to attach the seat and the back rest. Leave
screws loosely tightened until all screws are in place.
7Use four seat and back rest bracket screws (H) in the outer
back rest brackets to firmly attach the seat to the back rest.
Tighten all screws.
C 1pc Seat Post
D
1pc Seat Post Cover
F 1pc Seat
K 1pc Mechanism
G 3pcs Metal Bracket Screws
H 4pcs Seat and Back
Rest Bracket Screws
I 4pcs Mechanism Screws
J 2pcs Arm Width Adjustment
Knob and Washers
A 5pcs Casters
D
F
H
E
H
G
B
A
C
To Assemble:
Unpack and inspect contents to confirm you have all
pieces pictured.
1
Attach five casters (A) to the legs of the wheel base (B) as
shown in Figure 1.
2
Attach the seat post (C) to the wheel base and cover with the
seat post cover (D), with narrowest part at the top.
3
B 1pc Wheel Base
E 1pc Back Rest
Figure 1 Figure 2
L 2pcs Armrest
Page 1 of 2

©2014 ALVIN & COMPANY, INC. • P.O. Box 188, Windsor, CT 06095-0722
Phone: [phone] • Toll-Free: 800-444-2584 • Fax: [phone] • Toll-Free Fax: [phone]
www.alvinco.com
LIT-A140 93-1 7/14
Figure 3
8Place the chair face down on a sturdy table so that the
bottom of the seat is facing up. See Figure 3.
9Align the mechanism (K) with the holes in the center of the
chair base, making sure the front indicator is facing the front
of the chair.
10 Use the four mechanism screws (I) to attach the mechanism
to the seat bottom. Tighten all four mechanism screws firmly.
11 Slide the right armrest (L) into the right arm bracket until
the hole in the armrest aligns with the hole in the arm bracket.
Use one arm width adjustment knob and washer (J) to
tighten the armrest to the seat bottom. Tighten knob firmly.
Repeat for the left armrest.
12 Place assembled wheel base securely into the assembled
seat, making sure the seat post is firmly inserted into
the mechanism.
13 Flip chair right side up. Your chair is ready to use.
I
J
L
K
L
J
For model
CH300-40
Page 2 of 2
Olympian Chair (Office Height)
Assembly Instructions