ALZO 600 User manual

2/29/2016 ALZO600Assembly&UserGuide
http://www.alzodigital.com/customer_support/assy_alzo_600_user_guidespotify.htm 1/3
ALZO600ASSEMBLY&USERGUIDE
IncludedinasingleALZO600CoolLitekit::
1LightChassis
4Reflectors
45500Kdaylightcompactfluorescentbulbs45WATTseach
1PowerCord
1MountingBracket(attachedtochassis)
1ALZOAluminumLightStand?10?max.height
1Fabricdiffuser(removable/optional)
Thereflectorsareinsertedasshownaboveand
interlocked.
Afterthereflectorsareinsertedinthechassisthelight
shouldbeplacedonalightstandwithlegsinafullyopen
stableposition.Tightenthelightstandtripodbasewing
screwsecurely.Theheightofthestandshouldbe
adjustedtoashoulderheightorlowerposition.


2/29/2016 ALZO600Assembly&UserGuide
http://www.alzodigital.com/customer_support/assy_alzo_600_user_guidespotify.htm 2/3

Thelightheadshouldbemountedonthelightstandby
insertingthestandmountintothemountingbracketas
shownontheright.Tightenthewingnutscrewonthe
mountingbrackettosecurethelighttothestand.

Thetiltadjustmentiscontrolledbyslowlyturningthetwo
sidewingscrewscounterclockwisetoloosenwhileholding
thetopofthelighttopreventitfromfalling.Rotatethe
lightheadwhileholdingthetopofthefixtureandthen
tightenoneofthewingscrewsclockwisetolockthetiltof
thelight.Thentightentheotherwingscrew.
BulbInstallation
Donotovertightenthebulbs.Overtighteningthe
bulbscandamagethebulbandtheALZO600lighthead.
TheALZO600issuppliedwithfour(4)45wattPhoto
CompactFluorescentbulbswithamaximumTungsten
equivalentlightoutputof600watts.
Substitutingotherbulbsmayvoidthewarranty.

BasicOperation
Assurethatallfourlightswitchesareturnedoff(i.e.
rockerdown).Nowconnectthepowercordtothebackof
thelightandthena117volt60HZpowersource.Raisethe
lighttoaworkingheightandadjustthetiltofthelight
head.PressthefourpowerswitchestotheONposition
forfullpoweroranycombinationforlowerpower

IntensityAdjustment
ThefourbulbsintheALZO600canbecontrolled
independently.

OptionalDiffuser
Tosoftenshadowsandinsureproperdisbursementof
lightfromtheALZO600,placetheenclosedoptional
diffuseroverthereflectors.Toinstallthediffusermatch
thecornersofthediffuserwiththecornerscreatedbythe
reflectorsandstretchthediffuseroverthereflectors.

OptionalUmbrella
Toinstallumbrella:1)removeall4reflectors2)open
theumbrella3)placecenterpolethroughholeincenter
oflightchassis4)turnlightheadaround.Thelighthead

2/29/2016 ALZO600Assembly&UserGuide
http://www.alzodigital.com/customer_support/assy_alzo_600_user_guidespotify.htm 3/3
mustbeatleastfourfeetfromsubjecttooptimizethe
lightfromtheumbrella.