Amart Furniture Signature 64476 User manual

ASSEMBLY INSTRUCTION
DIMITRI DINING CHAIR
ITEM CODE 64476
Imported by Amart Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please phone
Amart Furniture, Customer Service Free call 1800 351 084

CARE AND MAINTENANCE GUIDE FOR YOUR
DIMITRI DINING CHAIR
REGULAR CARE:
• Protect from direct sunlight
•Vacuum regularly using low suction
CLEANING:
• Do not wash , Do not dry clean , Do not shampoo clean
• Clean with hot water extraction machine. Professional cleaning recommended
• Do not use dishwashing liquid or laundry detergent
• Use only upholstery detergents
• Do not wet filling
• Dry in shade away from direct heat and sunlight
•Allow to dry thoroughly before re-use
SPOT CLEANING:
• Do not rub
• Do not spot clean with any solvent
• Treat spills and stains as soon as possible
• Gently scrape off any soil or mop any liquid from the surface of the fabric
• Apply proprietary cleaning agents strictly according to instructions to remove the residue of
the spill
•Do not saturate the fabric or interior with water or other cleaning liquids
WARNING:
Apply only water-based soil resist (fabric protection) treatments. Do not use aerosol products
* PILLING IS NOT A FABRIC DEFECT OR FAULT AND IS NOT COVERED BY WARRANTY
* PILLING IS A NORMAL OCCURRENCE CAUSED BY WEAR AND TEAR AND DOES NOT
AFFECT THE DURABILITY OR FUNCTIONALITY OF THE FABRIC AND IS EASILY
REMOVED
Do not:
· Use chair/stool as a ladder
· Climb on the chair/stool
ITEM CODE 644761

PRE-ASSEMBLY PREPARATION
Before you start:
1. Choose a clean, level, spacious assembly area. Avoid hard surfaces that
may damage the product
2. Take care when lifting. Product should be assembled as near as possible
to the point of use
3. Ensure that you have all required contents for complete assembly
4. Always read the assembly instructions carefully before beginning
assembly.
5. Keep all hardware parts and packaging out of reach of small children.
6. Do not over tighten the screws and bolts as this may damage the
threads
15
1
ITEM CODE 644762

ITEM CODE 64476
PARTS LIST
1 SEAT BASE
2 FRONT LEGS (2)
3 LEFT REAR LEG (3)
4 RIGHT REAR LEG (4)
ATTENTION!
Legs are numbered and marked as such, they are not interchangeable
3

Step 1: Bolt preparation
Prepare by assembling the 8 bolts, spring washers and washers
as shown.
Step 2: Seat base preparation
Place the seat base upside down on an even, protected and flat
surface. Do not leave the seat base unbalanced and
unattended in this position.
ITEM CODE 644764

ITEM CODE 644765
Step 3: Inserting the legs
Insert the front legs (2) into the corresponding slots, they are
marked. The front legs are interchangeable and do not
distinguish between left and right. Then insert legs 3 and 4
into their designated slots, these are not interchangeable.
Step 3: Affixing the bolts
Insert the pre-assembled bolts into the holes as shown above.
Turn and tighten with Allen key provided (D). On Each leg, start
by only fastening each bolt to half way. Once both bolts are in,
then tighten both. Bolts should be tightened until all the way in.
Large visible gaps between components is a sign of not be tight
enough. Also do not over tighten, if you hear cracking in the
wood, stop. Tighten by hand only. Repeat for the other 3 legs

ITEM CODE 644766
Hint
Minor Adjustments can be made on the chair’s legs for
balance by slightly loosening, jiggling and retightening.
Assembly is complete