American Dynamics SpeedDome Ultra VII Installation and operating instructions

SPEEDDOME ULTRA VII CAMERA DOME CONFIGURATION UTILITY ADDENDUM TO MANUALS (8200-0184-06, REV. C1)
1 of 1
SpeedDome® Ultra VII
Camera Dome
Configuration Utility
Addendum to Manuals
This addendum applies to domes shipped with
firmware version 0710-0147-0102 or later. The
following documents are affected:
SpeedDome Ultra VII 22x Camera Dome
Configuration Utility Operator’s Manual
(PN 8200-0184-02)
SpeedDome Ultra VII Day/Night Camera Dome
Configuration Utility Operator’s Manual
(PN 8200-0184-04)
Freeze Frame Performance
Notes
The Freeze Frame feature allows the current
image to be maintained on-screen when switching
to a preset or pattern. If presets or patterns are
included as part of a sequence or tour, the total
movement and lens adjustment time should be
included as part of the dwell time to ensure that the
scene will be displayed before moving to the next
scene.
Note: This information also applies if you attempt
to rapidly call up a series of presets or patterns
without allowing the dome to adjust to the final
position for the preset or pattern.
For example, if it takes 2 seconds for the dome to
adjust from displaying Preset 1 to Preset 2, the
2-second adjustment time should be factored into
the sequence/tour dwell time. If the dwell time is
set for 10 seconds, only 8 seconds of live video
from the Preset 2 will be seen before the next
event in the sequence is displayed.
The following formula may be useful when
calculating actual viewing time for events in a
sequence or tour:
Dwell
Time
– Dome
Adjustment
Time
= Actual Viewing
Time
© Sensormatic 2003