American Standard Enfield 2-PC Elongated Toilet 2860.000 User manual

ENFIELD™ 2-PC
ELONGATED TOILET
VITREOUS CHINA
ENFIELD™ 2-PC ELONGATED TOILET
• Vitreous china
• Low-consumption (6.0 Lpf/1.6 gpf)
• Elongated siphon jet action bowl with 2”
trapway
• Rim height at 15” (381mm)
• AquaForce flushing technology
• Close-coupled tank with Satin Chrome finish
top-mounted liftrod actuator
• Includes solid hardwood seat with Satin
Chrome hinges and solid hardwood
decorative tank cap in either Maple or
Cherry finish to match Enfield furniture
• Internal trapway area fully glazed
• 100% factory flush tested
• Includes color-matched bolt caps
❏2860.330 Toilet complete with wood
accessories in Cherry finish
❏2860.334 Toilet complete with wood
accessories in Maple finish
❏2860.000 Toilet combination only without
hardwood seat and tank cap
❏3311.016 Elongated Bowl only
❏4060.016 Tank complete with Satin Chrome
finish lift rod actuator
❏9460.000 Tank rail trim, specify Cherry or
Maple
❏5380.295 Solid maple hardwood seat,
specify Cherry or Maple
Nominal Dimensions:
29-3/4" x 21-1/4" x 30-3/4"
(756 x 540 x 781mm)
Compliance Certifications -
Meets or Exceeds the Following Specifications:
• ASME A112.19.2M (and 19.6M) for Vitreous
China Fixtures - includes Flush Performance,
Ball Pass Diameter, Trap Seal Depth and
all Dimensions
To Be Specified
❏Color: ❏ White ❏ Linen
❏Decorative toilet angle stop and supply
in Satin finish
© 2002 American Standard Inc. TB-025
Revised 10/02
SPS 2860
19-1/2"
(495mm)
C/L OF SEAT POST
MTG HOLES ON
5-1/2" (140mm) CTRS
15-1/4"
(387mm)
6-3/8" (162mm)
14-5/8" (371mm)
11-1/4"
(286mm)
30-3/4"
(781mm)
C/L OF SUPPLY
AS REQUIRED
FINISHED
FLOOR
3/4" (13mm)
3-1/2" (89mm)
12"
(305mm)
21-1/4"
(540mm)
6" (152mm)
8"
(203mm)
C/L OF OUTLET AND
TOILET MTG BOLTS
29-3/4"
(756mm)
8-7/8"
(225mm)
1 ±1/4" (25 ±6mm)
FINISHED WALL
"
"
C/L
16-1/4"
(413mm)
TANK
TRIM
NOTES:
THIS COMBINATION IS DESIGNED TO ROUGH-IN AT A MINIMUM DIMENSION OF 305MM
(12") FROM FINISHED WALL TO C/L OF OUTLET.
*DIMENSIONS SHOWN FOR LOCATION OF SUPPLY IS SUGGESTED.
IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerance
established by ANSI Standard A112.19.2
These measurements are subject to change or cancellation. No responsibility is assumed for use
of superseded or voided pages.