American Standard 0545 Edgemere Sink User manual

NOTE: To avoid damage to
countertop, install sink such that
future removal from underneath
the countertop is possible.
First, make sure the clearance
between the backsplash, faucet,
fixtures and cabinets are
acceptable for the new sink.
Carefully cut out the enclosed template, then position and trace
the template on the countertop as shown on the template.
Make a mark of the faucet hole centerline on the countertop.
Drill a 1/2" pilot hole on the inside of the cut line. Use a saber
saw or a keyhole saw to cut out the countertop opening.
7302243-100 Rev. B 3/17
PERIMETER OF SINK
CUTOUT
1/2 MIN.
Clip
1/2 MIN.
Clip
FOR MARBLE OR SOLID SURFACE COUNTERTOP
FOR WOOD COUNTERTOP
12
34
Mark and pre-drill the wood screw holes as located on the
enclosed template. Waterproof any exposed areas of wood.
To protect countertop, place it on a foam padding
and drill 3/8 Dia. x 1/2 deep hole as per location
shown on template.
Drill 1/8 dia. x 3/8 deep
#10 Wood Screw
Brass insert, epoxy in place
with threaded end exposed.
(Epoxy not supplied.)
#10-32 Machine screw
CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!
NOTE: Pictures may not exactly define contour of china and components.
INSTALLATION INSTRUCTIONS
Undercounter Sink
0545 Edgemere™Sink
Introduction: Thank you for selecting our products...products which have been the benchmarks of fine quality for years. To help
ensure that the installation process will proceed smoothly, please read these instructions carefully before you begin. Also, review
the recommended tools and materials list; carefully unpack and examine your new plumbing fixture.
!
Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2017
Recommended Tools & Materials
Observe Local Plumbing and Building Codes.
Product names listed herein are trademarks of American Standard Inc. unless otherwise noted.
Adjustable Wrench Channel Lock Pliers
Regular Screwdriver
Phillips Screwdriver
10'
Pipe Wrench
Putty Knife Silicone Adhesive
Basin Wrench
Plumbers' Putty
Tubing Cutter
Tape Measure
Hacksaw
Saber Saw
NOTE: More specialized tools may be necessary to install this sink to
countertop materials other than wood or wood composites.
Drill
SAVE FOR FUTURE USE

7302243-100 Rev. B 3/17
Center bowl over cutout and
tighten screws (see 3 or 4) to
secure bowl to countertop.
Remove excess sealant from
inside lip.
NOTE: The screws provided
should be used on
countertops with a minimum
1" thickness. For thinner
countertops, use appropriate
anchors and fasteners.
NOTE: Do not use adhesives or
adhesive sealants. After checking fit
and alignment of sink to cut out,
apply a bead of silicone adhesive to
rim of sink.
56
78
910
A
Mount the drain assembly
(not included) on the sink,
following faucet
manufacturer's instructions.
Be certain to apply a bead
of sealing putty on the
underside of the drain (Part
"A") in order to ensure a
watertight seal between the
sink and drain. Remove
excess putty after installing
drain on sink.
B
C
Connect supply line to
faucet (finger tight) and
carefully bend tubes to
engage with the supply
shut-off valves. Tighten
connections at faucet
and shut-off valves for
water tight seal.
Connect trap to drain assembly hand
tight to check alignment. It may be
necessary to cut off part of the
tailpiece (area "B") or part of the
horizontal leg of the trap (area "C").
Secure joints for watertight assembly.
Install faucet (not included) and countertop (not included)
following manufacturers instructions.
Shut-Off
Valves
AS AMERICA, INC. ONE YEAR LIMITED WARRANTY
If inspection of this AS America, Inc. (“American Standard”) plumbing product, within one year after its initial purchase, confirms that it is defective in
materials or workmanship, American Standard will repair or, at its option, exchange the product for a similar model.
This limited warranty applies only to the original purchaser and installation of these products. In the event of a limited warranty claim, proof of purchase
will be required—save sales receipt.
This limited warranty does not apply to local building code compliance. Since local building codes vary considerably, the purchaser of this product
should check with a local building or plumbing contractor to insure local code compliance before installation.
This limited warranty is void if the product has been moved from its initial place of installation; if it has been subjected to faulty maintenance, abuse,
misuse, accident or other damages; if it was not installed in accordance with American Standard's instructions; or if it has been modified in a manner
inconsistent with the product as shipped by American Standard.
American Standard's option to repair or exchange the product under this limited warranty does not cover any labor or other costs of removal or
installation. IN NO EVENT WILL AMERICAN STANDARD BE LIABLE FOR THE COST OF REPAIR OR REPLACEMENT OF ANY INSTALLATION
MATERIALS, INCLUDING BUT NOT LIMITED TO, TILES, MARBLE, ETC. American Standard will not be responsible for any other incidental or
consequential damages attributable to a product defect or to the repair or exchange of a defective product, all of which are expressly excluded from this
limited warranty. This limited warranty does not cover any liability for consequential or incidental damages, all of which are hereby expressly
disclaimed, or the extension beyond the duration of this limited warranty of any implied limited warranties, including those of merchantability or fitness
for an intended purpose. (Some states or provinces do not allow the exclusion or limitation of implied limited warranties, so this exclusion may not
apply to you.)
This limited warranty gives you specific legal rights. You may have other statutory rights that vary from state to state or from province to province, in
which case this limited warranty does not affect such statutory rights.
In the United States:
American Standard Brands
1 Centennial Ave.
Piscataway, New Jersey 08854
Attention: Director of Customer Care
For residents of the United States, warranty
information may also be obtained by calling
the following toll free number: [phone]
www.americanstandard.com
In Canada:
AS Canada, ULC
5900 Avebury Rd.
Mississauga, Ontario
Canada L5R 3M3
Toll Free: [phone]
www.americanstandard.ca
In Mexico:
American Standard B&K Mexico
S. de R.L. de C.V.
Via Morelos #330
Col. Santa Clara
Ecatepec 55540 Edo. Mexico
Toll Free: 01-800-839-1200
www.americanstandard.com.mx