System Temperature
1st Press: Press and hold to power on. TCS will heat to 90º.
2nd Press: TCS heats to 104º.
3rd Press: TCS turns o.
*Thermal Comfort System requires 10-15 minutes to reach heat level.
Auto-O Function
Thermal Comfort System has a 30 minute auto-o function that allows you
to safely enjoy a bathing system like no other. The TCS is eco-friendly and
consumes less energy than a common 60 watt light bulb.
tub
controll pad
controll box
thermal comfort system
GFCI
outlet
CAREFULLY READ AND FOLLOW ALL INSTRUCTIONS before attempting to operate your whirlpool or Airbath® Bathtub.
ELECTRICAL REQUIREMENTS
Manufacturer recommends a dedicated 20 amp circuit breaker for each
power cord supplied on your whirlpool bathtub. WARNING - When
using electrical products, basic precautions should always be followed,
including the following:
1. DANGER: Risk of electric shock. Connect only to a supply circuit
protected by a Class A ground-fault circuit-interrupter (GFCI). Test
on a routine basis.
2. Grounding is required. The unit should be installed by a qualied
service representative and grounded.
3. (For built-in and custom units) install to permit access for servicing.
4. Supply 110 Volt electrical outlet. This circuit must be protected by a
ground fault circuit interrupter (GFCI.)
5. Plug supply cord(s) into electrical outlet.
6. To test the GFCI, do the following:
a. Push the test button;
b. Check to see that power has been interrupted;
c. Push the reset button;
d. Check to see that power has been restored.
If the GFCI does not operate properly during the test, there is a ground
current owing indicating the risk of electric shock. Do not use this
unit. Disconnect the unit and have the problem corrected by a qualied
service representative before using.
Refer to Operating Instructions for system operations and wiring
diagrams.
PERFORMANCE
US•CA
E87277
IMPORTANT SAFETY INSTRUCTIONS: pertaining to a risk of fire, electric shock, or injury to persons
Warning: Whirlpool bathtubs utilize acrylic and fiberglass materials (which are inherently slippery surfaces), electricity, water, air pressure and suction. The following basic
safety precautions should always be followed when using your bathtub.
READ AND SAVE THESE INSTRUCTIONS
©10/16
operating instructions
Thermal Comfort System (TCS)®
