Amico Majestic Series Lite User manual

Corporation
Installation Instructions
Horizontal Headwall
Majestic Series Lite

2Amico Architectural
Note
The installation instructions provided are for the Amico standard products. Slight modications
to the installations may be required. The product shipped to the job site may not be exactly as
shown on the installation drawings.
Headwall installation should conform to local building codes

www.amico.com 3
Before Installation
1. Review a copy of the nal approved shop drawing(s) and/or submittal package. These
documents will provide you with technical information specic to your installation, such as:
• equipment types and quantities
• room numbers and location
• shop drawings of each unit type
• wiring diagrams and rough-in locations
2. Locate the headwall unit from the shipping boxes that you wish to install.
The contents of each shipping box are listed on the shipping document(s).
Caution
Please do not lift headwall by the plastic end caps

4Amico Architectural
Installation
2. Mark horizontal line for bottom of mounting bracket (to be installed later). This line is to be o-
set 4” (102 mm) above devices center line.
4
devices center line AFF
bottom of mounting
bracket line AFF
1. Using shop drawings, mark both devices center line AFF (above nished oor) on wall.
devices center line AFF
Unit shown for reference only
Note

www.amico.com 5
Installation
3. Using a stud locator, mark the location of any metal studs in the building wall that intersect the
headwall mounting location.
stud
drywall
stud reference line
wall
nished oor
4. Mount the bracket(s) on the wall using hardware compliant to local building codes (supplied
by others). Align bracket(s) horizontally according to headwall mounting location. Refer to
drawings. Bracket includes I.D. marks for locating holes vertically, which are to be drilled on-site
according to location of studs. Remember to align bottom of bracket to“bottom of bracket” line
marked in step “2”.
bottom of
mounting
bracket line
bottom of mounting
bracket lines
bracket
I.D. mark for holes

6Amico Architectural
Installation
5. Check rough-in drawing(s) for electrical rough-in locations. Remove any device cover plates
preventing removal of fascia, if necessary, then remove fascia panel(s) for access to rough-in
locations.
rough-in cutouts
6. Hang the headwall unit on the wall, over the mounting bracket, and center the unit with refer-
ence to bed center line. Verify rough-in locations in wall and align with rough-in provisions on
headwall.
7. Make all necessary electrical connections at rough-in locations.
End plate and cover removed for clarity.
Do not remove!
Note

www.amico.com 7
Installation
8. Remove lower cover for mounting access. Secure headwall to the wall through lower section
using hardware compliant to local building codes (provided by others). Lower bracket is to be
drilled on-site according to stud location. Replace cover when done.
9. Replace any fascia panels and covers removed in step 5.
lower mounting locations

C US LISTED
Amico Architectural | www.amico.com
85 Fulton Way, Richmond Hill
Ontario, L4B 2N4, Canada
71 East Industry Court, Deer Park
NY 11729, U.S.A
Toll Free Tel: [phone]
Toll Free Fax: [phone]
Tel: [phone]
Fax: [phone]
Email: [e-mail] INSTALL INSTR. MAJESTIC LT HORIZ HDWL 2011
www.amico.com