AML Striker User manual

Power Button
(see instructions on reverse
side of this guide)
LCD
Front-Facing Speaker
1.1. 2.2.
3.3.
Open “Settings Turn ON WiFi
Select network
or ?to select
hidden networks
Getting StartedGetting StartedGetting Started
Isometric Front Bottom ViewTop and Rear Views
Striker Enterprise Mobile
Computer Quick-Start Guide
800.648.4452
www.amltd.com
051420-1
1.1. 2.2.
3.3. 4.4.
Slide the black
tab down
Pull battery door in the
direction shown
Remove/ replace
battery
Replace battery door and slide
tab to locked position
1Load the main battery 2Charging your Striker 3Setting Up Wi-Fi Connection
ACC-7725
Charging Cradle
9001-M7700 revA
Audio Jack
Microphones
Battery Door
LED Flashlight
Barcode Scanner
Flashlight Trigger
Scan Trigger
4.4. Connect
12V DC, 2.5A
Power supply
AML Part#: PWR-8050,
supplied with ACC-7725

© 2020 AML. All rights reserved.
AML reserves the right to make changes in specifications
and other information contained in this document without
prior notice, and the reader should in all cases consult
AML to determine whether any such changes have been
made. The information in this publication does not
represent a commitment on the part of AML. AML shall not
be liable for technical or editorial errors or omissions
contained herein; nor for incidental or consequential
damages resulting from the furnishing, performance, or use
of this material. This document contains proprietary
information which is protected by copyright. All rights
are reserved. No part of this document may be
photocopied, reproduced, or translated into another
language without the prior written consent of AML.
2190 Regal Parkway
Euless, TX 76040
800.648.4452
www.amltd.com
www.barcodepower.com
Safety NOM/NYCE-NOM-019-SCFI-1998
Safety of data processing equipment
Regulatory NoticeAccessories
Register Your ProductGetting Started
Warranty Agreements
SVC-EW7700
SVC-EWP7700
Extended Warranty, 3 year, M7700
Extended Warranty PLUS, 3 year, M7700
ACC-7725
Striker Single Slot
Charging Cradle
ACC-7735
4-Position
Battery
Charger
CAS-7701H
Holster with
Belt
ACC-7736
Striker Mobile
Charging Cradle
1. Press and hold power
button In order to help facilitate
support inquiries please register
your product.
You can register your
product(s) online at
www.amltd.com/registerwww.amltd.com/register
Laser Devices
Class 2 laser scanners use a low power, visible light diode.
As with any very bright light source, such as the sun, the
user should avoid staring directly into the light beam.
Momentary exposure to a Class 2 laser is not known to be
harmful.
The following statement is required to comply with US and
international regulations.
Label Reads
COMPLIES WITH 21CFR1040.10 AND 1040.11
AVOID EXPOSURE.
LASER RADIATION EMITTED FROM THIS APERTURE
CAUTION
LASER RADIATION
DO NOT STARE INTO BEAM!
630-680nm LASER
1.0 MILLIWATT MAXIMUM OUTPUT
CLASS II LASER PRODUCT
LED Devices
For LED devices which have been evaluated to IEC 62471 and
comply with the Exempt Risk Group, no product labeling requirements
apply.
Howerver, the following statement is required to comply with US and
international regulations:
LED Compliance Statement:
Classified as ‘EXEMPT RISK GROUP’ according to IEC 62471:2006
and EN 62471:2008.
NO USER SERVICEABLE PARTS
CAUTION Use of controls, adjustments, or the
performance of procedures other than
those specified herein may result in
hazardous laser light exposure.
Getting Started
2. Use the bar which appears on the
Striker’s screen to power off
Note: pressing the red power button
without holding will activate Sleep Mode
only.
4Turning Off the Striker 5Access Documentation
1.1. Visit the website:
www.amltd.com 2.2. Click on Support in
the Main Menu
3.3. Click on Product
Documentation 4.4. Documentation below found under Striker
• Wi-Fi Setup
• Barcode App
• Lockdown Utility
• Clone Utility for USB and PC
• Firmware Updates
• Sideloading an Application