AMS Strata Electric Lite Straight Desk User manual

Straight Workstation
Assembly Instructions
Flexible Options.Consistent Style. Enduring Quality.

STRATA ELECTRIC LITE
2
Parts
A - Frame (1) B - Columns (2)
C - End Pipes (2) D - Feet (2)
Before beginning assembly of a Strata Electric Lite Straight Workstation, please ensure you
have all of the below listed parts and in the specified quantities.

A
Image Screw Description Qty Tool
B
C
D
E
F
G
Screw for Woodtop
10# x 7/8
Screw for Column
M6 x 16mm
Screw for Foot
M10 x 16mm
Screw for Control
M4 x 25mm
Screw for Endpipe
M6 x 12mm
4mm Allen Key
5mm Allen Key
18
8
8
2
8
1
1
Phillips Screw Driver
or Cordless Drill
Phillips Screw Driver
or Cordless Drill
4mm Allen Key
5mm Allen Key
4mm Allen Key
Hand
Hand
3
Hardware
Straight Desk Assembly Instructions

4
Step 1
Carefully move the Frame (A) onto the worktop.
Step 2
Adjust the Frame (A) to an appropriate width to suit the worktop, then use an
Allen Key to tighten the 8 frame screws.
STRATA ELECTRIC LITE

5
Step 3
Insert 2 End Pipes (C) into ends of Frame (A).
Straight Desk Assembly Instructions

6
Step 4
Attach Columns (B) to the Frame (A) with screws (B).
B
STRATA ELECTRIC LITE

7
Step 5
Hold the Column (B) on an angle and carefully insert into position, then attach with 4 screws (B).
B
Straight Desk Assembly Instructions

8
Step 6
Press down on both Columns (B).
Step 7
Connect the Gearbar to the Drive Shaft.
STRATA ELECTRIC LITE

9
Step 8
Attach Feet (D) to the Columns (B) using bolts (C).
Step 9
Screw the Frame (A) and control into the worktop using 14 x A screws and 2 x E screws.
B
Straight Desk Assembly Instructions

10
Step 10
Flip over the desk. Caution: Flip table carefully.
Step 11
To finish setup, perform reset:
1. Press and hold down both Up and Down buttons on the Handset at the
same time for 3 seconds.
2. Continue pressing the buttons until all legs are in the lowest position.
3. When finished reset, the control box makes an alert sound, and the buttons can be
released.
STRATA ELECTRIC LITE