EasyPrinter S3 Programmers Manual
Contents
Command description................................................4
Printer short state....................................................................4
Start printing .........................................................................4
Firmwareversion......................................................................4
Read printer state....................................................................5
Read direction detection values ................................................5
Read RFID card number...........................................................5
Reset printer ..........................................................................5
Select small font .....................................................................6
Select medium font .................................................................6
Select big font ........................................................................6
Rotate card b 180 degrees .....................................................6
Rotate card b 0 degrees .........................................................6
Print text portrait ....................................................................6
Print text landscape ................................................................6
Print character in double height ................................................6
Print character in double width .................................................7
Feed card...............................................................................7
Enable printer.........................................................................7
Disable printer .......................................................................7
Exit card ................................................................................7
Set -Position .........................................................................7
Set x-Position .........................................................................8
Set print area .........................................................................8
Set erase area ........................................................................8
Set erase area mode (non permanent) ......................................8
Get permanent erase area mode ..............................................9
Set permanent erase area mode ...............................................9
Paperticket mode.....................................................................9
Command for graphic data.......................................................9
Command for graphic data (Intercard ONLY!!!)...........................9
Command for microlinefeed ...................................................10
Start Loader..........................................................................10
Set erase area ......................................................................10
Read printers error code ........................................................10
Read magnetic card JIS II ......................................................11
Reboot.................................................................................11
Get printenerg -offset (permanent) ........................................11
Get eraseenerg -offset (permanent)........................................11
Set temporar printenerg -offset (NOT permanent)...................11
Set printenerg -offset (permanent).........................................12
Set eraseenerg -offset (permanent)........................................12
Set displa text.....................................................................12
Set displa controlled b printer firmware.................................12
Select card............................................................................12
Read cardnumber..................................................................13
Page 2 of 23 Version 1.3 - 19. April 2012
