Angelcare AC527 User manual

AC527: How to install the Movement Sensor
Pad
You're now ready to install your Angelcare Movement Sensor Pad. Here is the procedure to
install and set the sensitivity:
1. Remove the battery cover of the Sensor Pad with a coin and insert the battery face with +
face up
2. Replace the battery cover, align 2 dots and click to secure
3. Remove the mattress from the crib, place Sensor Pad - Angelcare® logo side up - on base
in the approximate centre of the mattress.
oIf your crib does not have a solid, stationary, completely flat, firm surface
including a spring base, place a hardboard between the crib base and the Sensor
Pad, to ensure correct operation. The hardboard support must measure at least 30
x 30 cm (12” x 12”) and 6 mm (1/4”) thick. This hardboard support must be larger
than the Sensor Pad surface area. The hardboard maintains a constant pressure on
the Sensor Pad, enabling it to detect the baby’s movements even when the baby is
at the edges of the crib
oIf your crib has a slatted base, make sure the edges of your Sensor Pad are placed
a held over 2 slates.
4. Replace the mattress

Here is a small video to show you how easy it is!
IMPORTANT: The Sensor Pad functions with standard crib sprung and foam mattresses and
NOT memory foam (partial or full), hollow frame construction mattresses and water beds.
When the Sensor Pad is in place, proceed to the 4 corner test to set the optimal Sensor Pad
sensitivity for your crib.
SENSOR PAD FOUR CORNER TEST
1. Place the Sensor Pad at the approximate centre of the baby’s sleeping area and put the
mattress back in place
2. Switch ON both Nursery & Parent Units –check both units are paired (connected)
3. Immediately pat your hand lightly and continuously on a corner of the mattress twice for
Sensor to detect movement. If movement is detected you will hear a TIC sound (if TIC
feature is activated) every 5 seconds and PU will flash green for a single Sensor Pad
4. Step away from the crib
5. The alarm will sound from the Nursery and Parent Unit after 20 seconds. If the Alarm
does not sound, ensure everything is set up correctly and try again; check battery levels
on all units, search for the article entitled ‘AC527 NOT ALARMING’– as the sensitivity
setting may require lowering by a single level due to other vibrations/movements
6. If the alarm does sound, pat your hand lightly on a corner of mattress twice for Sensor to
detect movement.
NOTE: It can take up to 8 seconds for the Sensor Pad to recognize movement and for the
alarm to stop
7. If the alarm continues, even after lightly patting the corner of your mattress twice, adjust
the sensitivity higher (up one level) and repeat this test
Here is how to set movement sensitivity of the Sensor Pad:
IMPORTANT
Test your monitor before first use
Prior to use and on a regular basis (before placing your child in the crib) always check the
Sensor Pad is not detecting any movements or vibrations in its environment
Test your monitor every time you move the Sensor Pad to a different place