We do recommend that you clear any pairing for all the devices before pairing in a group
How to Clear Pairing on the Device(s)?
Quick Start Guide
0Press and Hold the control / test button. Release the control / test button When the Green Light Have Flashed
4 Times
For AJ interlink series alarms
For the Remote Controller
Press and hold the test button, release the test button when the red light have ashed 4 times
1 Short Beep Follow By 1 Long Beep then 1 Short Beep Follow By 1 Long Beep
© 2022 - ANKA | All Right Reserved
ANKA-TECH V5
4After pairing all devices, go back to main device and press the control button once to nish group pairing
2Choose one to be your main device, press and hold the control button, release the control button when the
green light have ashed 3 times. Please take care not to release the button too early!
(If you choose the remote controller to be main device, press and hold the test button.
Release the test button when the red light have ashed 3 times)
1 Short beep follow by 1 long beep then red light ash continuously (no sound for remote control)
3On other device(s), press and hold the control button, release the control button when the green light have
ashed 2 times. (If you choose the remote controller to be pairing device, press and hold
the test button. Release the test button when the red light have ashed 2 times)
1 Short beep follow by 1 long beep then red light ash 2 times (no sound for the remote control)
5Press the main device control button once to test the alarm, after 3~4 seconds, the paired devices will activite
and sound the alarm one by one. Press main device & paired devices control button once to cancel test.
Caution : Loud Beeps
1
For Heat Alarm AJ-718 Please Go to Image
How to Switch On Alarms?
For Smoke AlarmAJ-761SI4,AJ-762SI4, AJ-763SI4,Please Go to Image
For Carbon Monoxide Alarm AJ-83XSI Please Go to Image
For Remote Controller AJ-R1062 Please Go to Image
* If you pairing additional devices to the group, you only need to use one of the devices
in the group to link the new device(s) to the exisiting group.
*For Pairing Additional Alarms / Remote Controller, Please Start From 2
A
B
C
D
