Ankom A01 User manual

Service Procedure AS024
Rev. B Date: 09/13/2017
A01 Cubetainer Shelf Installaon
A2000/A2000I
2052 O’Neil Rd Macedon, NY 14502 PH: [phone] FAX: [phone]
serv[email protected]
1. Lay the shelf as shown in the picture on
right. Remove the six nuts from inside the
Shelf Plaorm (red arrows).
2. Aach the Le and Right Support Brackets, and fasten
the nuts back on. Make sure the brackets are oriented
correctly.
3. Using a screw driver, remove the screws (red arrows
from the Support Post.
4. Secure the Triangular Back Brace to the support
post so the outside corners face away from the
leveling mount. Replace the screws.
C6/25/19

Service Procedure AS024
Rev. B Date: 09/13/2017
A01 Cubetainer Shelf Installaon
A2000/A2000I
2052 O’Neil Rd Macedon, NY 14502 PH: [phone] FAX: [phone]
[email protected]
5. With the inside facing up, aach the Support Post
into the center of the Shelf Plaorm (red arrows).
6. Remove six nuts from the back of the A2000 (red
arrows).
7. Slide on the Le and Right Support Brackets and
the Triangular Back Brace as shown (red arrows),
then replace the nuts. Adjust the Leveling Foot
(blue arrow) as needed to support the bracket. The
foam strip should rest on the top of the A2000.
C6/25/19
Final view of A2000 with Cubetainer shelf installaon