Questions? Call us at 800.325.3841 or visit anthro.com. We’re happy to walk you through the assembly!
CONGRATULATIONS! YOUR SURGE PROTECTOR ASSEMBLY IS COMPLETE!
*300-5111-00*
300-5111-00
January 2015 Rev A
Notices:
Technology Furniture is a trademark of Anthro
Corporation. Anthro reserves the right to
modify the design and specifications
without prior notice.
To Attach to a Vertical Leg:
Step 1
Insert two screws 10 holes apart at the desired height on your cart's vertical leg.
Drive the screws partially in (they should protrude about a quarter of an inch).
Note: Your surge protector will hang down from these screws. Be sure that there
is enough clearance for the surge protector.
STEP 2
With the power cord at the bottom, slide the slots on the back panel of the surge
protector over the screws.
STEP 2
Drill two small holes (being sure not to drill through the laminate) at the marked
locations.
To Attach under a Shelf:
Step 1
Decide the location where you want to attach the surge protector under your shelf.
With a pencil, mark drill holes 10" apart.
STEP 4
Slip the back, slotted panel of the surge protector over the screws.
STEP 3
Drive the screw partially in (it should protrude about a quarter of an inch).
Self-threading Screw
325-5010-00
3/4" Wood Screw
325-5106-00
This UL-listed surge suppressor
is 12" long, has 6 outlets and
is rated at 15 amps, 120 Volts.
Comes with on/off switch, on/
off indicator light, and circuit
breaker reset button.
Warranty:
For warranty information, please visit:
http://www.anthro.com/support/warranty
