806956A02
s
Installation Instructions / Instructivo de Instalación
Use only with Siemens certified Components.
Utilizar únicamente con componentes certificados de Siemens.
A utiliser uniquement avec les composants certifiés Siemens.
Turn off and lock out all power supplying this device before
working on this device.
Replace allcovers before power supplyingthis deviceis
turned on.
Couper l'alimentation de l'appareil et barrer avant de
travailler.
Remplacez touts les couverts avant que
l'approvisionnement de pouvoirsoit alimenté.
Tensión peligrosa.
Puede causar la muerte o lesiones graves. Tension dangereuse.
Danger de mort ou risque de blessures graves.
Hazardous Voltage.
Will cause death or serious injury.
Desenergice totalmente antes de instalar o darle servicio.
Reemplace todas las barreras y cubiertas antes de
energizar el interruptor.
Turn off and lock out all power supplying this device before
working on this device.
Replace allcovers before power supplyingthis deviceis
turned on.
Couper l'alimentation de l'appareil et barrer avant de
travailler.
Remplacez touts les couverts avant que
l'approvisionnement de pouvoirsoit alimenté.
Tensión peligrosa.
Puede causar la muerte o lesiones graves. Tension dangereuse.
Danger de mort ou risque de blessures graves.
Hazardous Voltage.
Will cause death or serious injury.
Desenergice totalmente antes de instalar o darle servicio.
Reemplace todas las barreras y cubiertas antes de
energizar el interruptor.
1 / 3 I.L. No. 806956A02
Item: HNM3M120 3VL7112-2KK30-0AA0
U.S. Cat. No. Euro Order No.
Motor Circuit Protector, Frame NG
Protector Del Circuito Del Motor, Caja Base NG
Protecteur De Circuit De Moteur, de Base NG
HNM3M120
3VL7112-2KK30-0AA0
1/4 - 20 x 4.0
MSKP4
M6 x 1.0 x 100mm
3VL98008SA40
1
Trip
[ Interrumpir ]
Ø = .28“
[ Ø = 7.1 ] 7/16“
Cal ISO 6789
NOTE - These instructions do not purport to cover all details
or variations in equipment, or to provide for every possible
contingency to be met in connection with installation,
operation or maintenance. Should further information be
desired or should particular problems arise, which are not
covered sufficiently for the purchaser’s purposes, the matter
should be referred to the local Siemens sales office. The
contents of this instruction manual shall not become part of
or modify any prior or existing agreement, commitment or
relationship. The sales contract contains the entire obligation
of Siemens. The warranty contained in the contract between
the parties is the sole warranty of Siemens. Any statements
contained herein do not create new warranties or modify the
existing warranty.
Trademarks - Unless otherwise noted, all names identified by
® are registered trademarks of Siemens AG or Siemens
Industry, Inc. The remaining trademarks in this publication
may be trademarks whose use by third parties for their own
purposes could violate the rights of the owner.
