AnyDATA ADU-510 User manual

ADU-510
(User Manual)
SW-ADU-510-UG-V1.0E(IUSACELL)
January 18. 2008
전자 메일로 제출인쇄 단추

AnyDATA.NET USB Modem (User
Manual)
AnyTime AnyPlace AnyWireless Data Solutions™ 2/65
AnyDATA CDMA Module Series Reference Design Specification
Copyright © 2000-2007 AnyDATA.N ET Inc. All Rights Reserved.
Any part of this document may not be distributed, communicated, reproduced or transmitted in any form
or by any means, electronic or mechanical or otherwise, for any purpose, without the permission
of
AnyDATA Corp.
This document can be subjected to revision without further notice
.
Contact Address
AnyDATA.NET Inc.(Korea)
DaeGo Bldg, 8th., 1591-10
Kwanyang-dong, Dongan_gu,
Anyang City, Kyunggi-do Korea.
http://www.anydata.co.kr
e-mail: [email protected]
Rep:[phone]
Fax:[phone]
FCC Warning: RF Exposure to Radio Frequency Radiation
The radiated output power of this device is below the FCC radio frequency exposure limits. Nevertheless,
the device should be used in such a manner that the potential for human contact during normal operation
is minimized. In order to avoid the possibility of exceeding the FCC radio frequency exposure limts, the
gain of the external antenna must not exceed 1dBi. This device is compliant with the parameters of
Specific Absorption Rate (SAR) government regulations.

AnyDATA.NET USB Modem (User
Manual)
AnyTime AnyPlace AnyWireless Data Solutions™ 3/65
Contents
1. ADU-510 Features .....................................................................................................................................
4
2. LED Indicators ...........................................................................................................................................
52.1 POWER ...............................................................................................................................................
5
2.2 IDLE / BUSY ........................................................................................................................................
5
3. Program Installation ..................................................................................................................................
63.1 Introduction ..........................................................................................................................................
6
3.2 Minimum System Requirement ............................................................................................................
63.2.1 PC Hardware .................................................................................................................................
6
3.2.2 Operating System .........................................................................................................................
6
3.3 USB Driver Installation and Uninstall (Windows 2000) ........................................................................
73.3.1 USB Driver Installation (Automatic) ..............................................................................................
7
3.3.2 USB Driver Installation (Manual) .................................................................................................
10
3.3.3 USB Driver Uninstall ...................................................................................................................
18
3.4 USB Driver Installation and Uninstall (Windows XP) .........................................................................
203.4.1 USB Driver Installation (Automatic) ............................................................................................
20
3.4.2 USB Driver Installation (Manual) .................................................................................................
23
3.4.3 USB Driver Uninstall ...................................................................................................................
29
3.5 USB Driver Installation and Uninstall (Windows Vista) ......................................................................
313.5.1 USB Driver Installation (Automatic) ............................................................................................
31
3.5.2 USB Driver Installation (Manual) .................................................................................................
34
3.5.3 USB Driver Uninstall ...................................................................................................................
41
3.6 Installing Easy Wireless Net Software ...........................................................................................
43
4. Using Easy Wireless Net Program ..........................................................................................................
474.1 Exiting the program ............................................................................................................................
47
4.2 Screen Display of Easy Wireless Net ................................................................................................
484.2.1 Executed Screen .........................................................................................................................
48
4.2.2 Descriptions of each icon ............................................................................................................
49
4.2.3 Descriptions for each button .......................................................................................................
50
4.2.4 Setting Environment ....................................................................................................................
51
4.2.5 Connecting to the Internet ...........................................................................................................
55
4.2.6 Disconnecting to the Internet ......................................................................................................
55
4.2.7 Sending and Receiving SMS ......................................................................................................
56 4.2.7.1 Writing New Message .................................................................................................................... 57
4.2.7.2 Viewing sent message ................................................................................................................... 59
4.2.7.3 Viewing received or saved message .............................................................................................. 60
4.2.8 Phonebook ..................................................................................................................................
61
5. Troubleshooting .......................................................................................................................................
62
6. Quick Guide .............................................................................................................................................
656.1 Display Indicators ..............................................................................................................................
65

AnyDATA.NET USB Modem (User
Manual)
AnyTime AnyPlace AnyWireless Data Solutions™ 4/65
1. ADU-510 Features
Ear Jack
LED
USB

AnyDATA.NET USB Modem (User
Manual)
AnyTime AnyPlace AnyWireless Data Solutions™ 5/65
2. LED Indicators
2.1 POWER
Mode Descriptions
RED Modem power on state
OFF Modem power off state
2.2 IDLE / BUSY
Mode Descriptions
GREEN Success to network acquisition (Idle state)
BLUE Data(Voice) call is connected
BLUE BLINK Incoming voice call and not connected yet
OFF No service or Searching the network

AnyDATA.NET USB Modem (User
Manual)
AnyTime AnyPlace AnyWireless Data Solutions™ 6/65
3. Program Installation
3.1 Introduction
This section describes step-by-step method to install ANYDATA.NET USB MODEM and Easy Wireless
Net Software.
Note : Must install the software before connecting ANYDATA.NET USB MODEM to PC/Notebook.
3.2 Minimum System Requirement
3.2.1 PC Hardware
Recommend to use PC/Notebook at speed of 300 MHz or higher.
Minimum 233 MHz speed required, * Intel Pentium/Celeron products,
AMD K6/Athlon/Duron products or compatible processors
Recommend to use 128MB RAM or higher
Minimum 64MB of memory must be used,
but in this case the performance will be degraded and certain features will be limited.
At least 100 MB of free hard disk space is required.
Motherboard or PCI card that supports USB.
Video adaptor with Super VGA (800 x 600) or higher resolution and Monitor
CD-ROM or DVD Optical Drive
Keyboard and Mouse
3.2.2 Operating System
Windows XP Home or Professional ( with Service Pack 2 )
Windows 2000 (with Service Pack 4 for optimal performances)
Windows Vista
< Recommended parameters >
Windows Update : Keep your computer up to date

AnyDATA.NET USB Modem (User
Manual)
AnyTime AnyPlace AnyWireless Data Solutions™ 7/65
3.3 USB Driver Installation and Uninstall (Windows 2000)
3.3.1 USB Driver Installation (Automatic)
1. The installation of the USB Wireless Modem Connect should run automatically upon selecting this
option on the menu of the Installation CD. Click <Install Modem Driver> on the menu.

AnyDATA.NET USB Modem (User
Manual)
AnyTime AnyPlace AnyWireless Data Solutions™ 8/65
2. The computer needs to restart after the driver installation completed.

AnyDATA.NET USB Modem (User
Manual)
AnyTime AnyPlace AnyWireless Data Solutions™ 9/65
3. Connect the modem and PC`s USB port, and check if the driver is installed properly in
<Device Manager>. See the followings to the location of <Device Manager>
[Start ▶Control Panel ▶System ▶Hardware Tab▶Device Manager]
As shown in below with red boxed that shows <AnyDATA CDMA USB Modem> and
<AnyDATA CDMA USB Serial 1/2 Device>, the driver has been successfully installed.

AnyDATA.NET USB Modem (User
Manual)
AnyTime AnyPlace AnyWireless Data Solutions™ 10/65
3.3.2 USB Driver Installation (Manual)
1. Connect the modem and PC`s USB port with supplied USB cable.
※The manual driver installation shall be required twice.
2. Installing <AnyDATA USB Modem Driver> window will appear.
Select <Search for a suitable driver for my device (recommended) >.
3. Press button to move to next step.

AnyDATA.NET USB Modem (User
Manual)
AnyTime AnyPlace AnyWireless Data Solutions™ 11/65
4. A window that displays a proper path of Driver will appear.
Select <CD-ROM drives> and press button.
5. Select from the CD`s path <CD Rom Drive: \\Driver\\> folder for appropriate OS.

AnyDATA.NET USB Modem (User
Manual)
AnyTime AnyPlace AnyWireless Data Solutions™ 12/65
6. A window that searches <AnyDATA CDMA USB Modem> will appear.
7. Press button to move to next step.
8. Process of installing <AnyDATA CDMA USB Modem>.

AnyDATA.NET USB Modem (User
Manual)
AnyTime AnyPlace AnyWireless Data Solutions™ 13/65
9. If the installation of <AnyDATA CDMA USB Modem> has been completed, following window
will
appear.

AnyDATA.NET USB Modem (User
Manual)
AnyTime AnyPlace AnyWireless Data Solutions™ 14/65
10. Next, it will install <AnyDATA CDMA USB Serial
Device>.
11. Select < Search for a suitable driver for my device (recommended)
>.
12. Press button to move to next step.

AnyDATA.NET USB Modem (User
Manual)
AnyTime AnyPlace AnyWireless Data Solutions™ 15/65
13. A window that displays a proper path of Driver will appear.
Select <CD-ROM drives> and press button.
14. Select from the CD`s path <CD Rom Drive: \\Driver\\> folder for appropriate OS.
15. Press button to move to next step.
16. Window that searches <AnyDATA CDMA USB Serial Device> will
appear.

AnyDATA.NET USB Modem (User
Manual)
AnyTime AnyPlace AnyWireless Data Solutions™ 16/65
17. Press button to move to next step.
This will complete the driver installation.

AnyDATA.NET USB Modem (User
Manual)
AnyTime AnyPlace AnyWireless Data Solutions™ 17/65
18. Connect the modem and PC`s USB port, and check if the driver is installed properly in
<Device Manager>. See the followings to the location of <Device Manager>
[Start▶Control Panel ▶System ▶Hardware Tab▶Device Manager]
As shown in below with red boxed that shows <AnyDATA CDMA USB Modem> and
<AnyDATA CDMA USB Serial 1/2 Device>, the driver has been successfully installed.

AnyDATA.NET USB Modem (User
Manual)
AnyTime AnyPlace AnyWireless Data Solutions™ 18/65
3.3.3 USB Driver Uninstall
1. Disconnect the modem from USB port before uninstalling the driver.
2. By clicking on under the driver folder in CD, this will start as shown below.
3. Select <Install> to uninstall the driver.
To stop removing the driver, select <Cancel>.

AnyDATA.NET USB Modem (User
Manual)
AnyTime AnyPlace AnyWireless Data Solutions™ 19/65
4. As shown below, click <Finish> then the driver will be uninstalled.
5. The computer must restart after the driver is uninstalled.

AnyDATA.NET USB Modem (User
Manual)
AnyTime AnyPlace AnyWireless Data Solutions™ 20/65
3.4 USB Driver Installation and Uninstall (Windows XP)
3.4.1 USB Driver Installation (Automatic)
1. The installation of the USB Wireless Modem Connect should run automatically upon selecting this
option on the menu of the Installation CD. Click <Install Modem Driver> on the menu.