Anyuta Werfer Granate BR21 Launcher User manual

Dear customer,
We thank you for buying our products and we appreciate your interest on
our 1/24 scale Werfer Granate BR-21 rocket launcher model kit which can
be installed under Focke Wulf Fw-190 or Messerschmitt Bf-109 wings.
In case you 'll notice slight traces of oil on the kit parts surface when
you got the item, it is absolutely normal. This oil is actually left after the
3D printing process was finished and the kit parts been removed from the
printer tray to be washed into an ultrasonic oil bath and later an
ultrasonic water bath and might escaped the clean inspection and dry by
hand procedure. So, if you notice oily traces, the 3D printed kit parts can
be cleaned easily by sinking everything into a plastic bowl filled with White
Spirit and then place them on soft paper towels and allow to dry.
Feel free to ask any help or info during your model building process. You
allready got the assembling instructions in your hands, but we'd like you
to know that Anyuta 3D will be always next to you for anything you might
need in order to build a realistic scale model for your showcase.
Regards,
Anyuta 3D print creations & scale models
http://www.shapeways.com/shops/anyuta3D

Werfer Granate BR21 launcher
1/24 scale 3d printed model kit by anyuta creations
The Werfer Granate BR21 rocket launcher, also known as the BordRakete
BR21, was developed by Rheinmetall Borsig and used by the German
Luftwaffe during World War II. Focke Wulf Fw-190A7 & Messerschmitt Bf-
109G single seat fighters carried a single tubed rocket under each wing,
while the Messerschmitt Bf-110, Messerschmitt Me 210 and Messerschmitt
Me 410 Hornisse twin engine fighters carried two under each wing.
STEP-BY-STEP MODEL KIT BUILDING INSTRUCTIONS
This is a Werfer Granate BR21 rocket launcher unassembled model kit
produced under 1/24 scale for aviation or military diorama enthousiasts &
scale modeler builders. This kit contains all necessary parts for
assembling ONE launcher model and ONE rocket under 1/24 scale. All
parts are 3D printed with Frosted Ultra Detail matte translucent plastic
material, which is highly recomended for best results on detail. Additional
diorama accessories are not included and should be purchased separately
from “ANYUTA 3d” online products catalog. For additional info, building
instructions & directions, contact with us and we ‘ll be happy to help.

The scale model kit contains eight (8) parts, 3D printed with Frosted Ultra Detail
matte translucent plastic material. Please check & identify each part closely before
proceeding to building process. Cyanoacrylate glue is recommended for best results.

Insert the disc shaped rear cap and close the hollowed ammunition shell as shown on
above picture. Use extra caution while installing rear cover & avoid violent moves to
prevent plastic fracture & secure in place by adding a cyanoacrylate superglue drop.

As soon as the ammunition shell is built, place it into launcher. Align the shell onto
the launching tube and slide backwards (marked with red arrow) carefully, as shown
on above picture. Then, secure in place by adding a drop of cyanoacrylate super glue.

The kit contains two pairs of different lengthed cylindrical shaped supporting bars.
These bars will be installed on selected points on launching tube as marked with red
arrows. Secure supporting bars in place by adding cyanoacrylate super glue drops.

The kit contains one central bolt equiped with hook, which is the main underwing
suspension point. Hook’s beam head should be aligned onto bolt’s slot (marked with
red arrow). Avoid violent moves while installing the hook on bolt to prevent damage.