APARTMENT B SOLO User manual

SOLO
ASSEMBLY INSTRUCTIONS
1270
750
Aust. Design Reg. no 201711368

STEP 1
Attach (H1) Back panel to (H2) RHS Back panel
(5x M6-16 screws)
STEP 2
Attach STEP 1 to (H3) LHS Back panel
(5x M6-16 screws)
STEP 3
Attach (H4) RHS Front panel to (H2) RHS Back panel
(5x M6-16 screws)
STEP 4
Attach (H5) LHS Front panel to (H3) LHS Back panel
(5x M6-16 screws)

STEP 5
Insert (H6) Floor Brace to (H4 and H5) RHS
panel and LHS panel at ground level
STEP 6
Attach (H7) Rear Top panel to (H2 and H3)
Rear LHS and Rear RHS
(11x M6-16 screws)
STEP 7
Attach (H8) Front Top panel to (H4 and H5)
Front LHS and Front RHS panels
(8x M6-16 screws)
A
A

STEP 8
Attach x4 Corner Brace Brackets
(8x M5-12 screws)
Fasten x4 self drilling screws to each side of the (H6)
Floor Braces to the corner flaps pre-aligned hole points
STEP 10, 11 & 12
10. Put locker in place and mark 12 preferred hole locations
11. Remove locker and drill holes
12. Reposition locker and bolt to the ground or base with
fasteners provided
(12x M8 50mm Hex Head Coach Screws and plugs)
STEP 13
Attach (H9) Door to (H5) LHS side panel with 3x hinge pins
Slots for hinge adjustment are provided for minor door
adjustment
B
B
I
I
I
I
I
I
I
I
II
I
I
I
I
I