Apera Instruments 2310T-F User manual

2310T-F High-Range Conductivity/Temp. Electrode
User Manual

Brief Introduction
Apera Instruments 2310T-F High-Range Conductivity/Temp. Electrode is featured with a proprietary
platinum black ring sensor for accurate readings in an ultra-wide conductivity range up to 2000 mS/cm,
along with a built-in temperature sensor for automatic temperature compensation.
Technical Specifications
Range
20 to 2000 mS/cm, 32 to 122°F (0 to
50°C)
Housing
POM
Constant
K=10
Connector
BNC/RCA
Cable length
3 Ft
Dimension
ø12*145 mm
Temperature sensor
30KΩ thermistor
Operating temperature
32 to 176°F (0 - 80°C)
How to Install the Electrode
1. Find the conductivity BNC socket (where it shows Cond) on the conductivity meter; Open the
rubber cap; Insert the BNC connector of the electrode to the BNC socket while twisting clockwise
until it’s locked.
2. Find the RCA socket (where it shows temp) on the meter; Open the rubber cap; Insert the black
RCA connector of the electrode to the RCA socket directly.
3. After connecting the new electrode to your meter, adjust the meter’s constant K to 10 according to
the instruction of your meter’s manual. Then perform a 2 to 3-point calibration to ensure the
accuracy.

How to Use the Electrode
1. There is a proper amount of deionized water in the cap on top of the electrode. The conductivity
sensor is soaked in it to keep its sensitivity.
2. Before measuring, loosen the bottle cap, then pull out the electrode while twisting
counterclockwise. Place the storage bottle at a safe position.
3. Rinse the electrode with distilled or deionized water and blot-dry it with clean tissue or filter paper.
Never rub the sensor. Rinse the electrode again with your test solution if possible for the best result.
4. Insert the electrode into your sample solution and stir it for a few seconds in the solution to remove
potential air bubbles. Then wait for the stable reading and take the measurement.
5. After measurement, insert the electrode back into the storage cap and twist it on. If the water in
the cap is contaminated, rinse out the storage cap and fill in new deionized or distilled water.
How to Maintain the Electrode
1. Always rinse the electrode with distilled or deionized water before and after each test and
calibration.
2. Store the electrode in the storage cap filled with distilled or deionized water when not in use.
3. Keep the electrode’s connector clean and dry. Use cotton balls with isopropyl alcohol to clean if
it gets dirty and then blow-dry it. This is to prevent a potential short circuit, which will
undermine the electrode’s performance.

Limited Warranty
We warrant this electrode to be free from defects in material and workmanship and agree to repair or
replace free of charge, at the option of APERA INSTRUMENTS, LLC, any malfunctioned or damaged
product attributable to responsibility of APERA INSTRUMENTS, LLC for a period of SIX MONTHS
from the delivery.
This warranty does not cover any damages due to:
Accidental damage, transportation, storage, improper use, failure to follow the product instructions,
unauthorized repair, normal wear and tear, or any other actions or events beyond our reasonable control.
APERA INSTRUMENTS, LLC
Address: 6656 Busch Blvd, Columbus, OH 43229 Phone: [phone]
Website: aperainst.com Email: [e-mail]