
2 / 3
PRODUCT OPERATION
PRODUCT INSTALLATION
First time operation
When abnormal conditions occur
Away from home
Restarting the system
Changing the filter cartridges
(1) Plug in the power supply. Allow several minutes for the system to flush and fill.
(2) Do not drink the first tank of water. About one to two hours after the system started, turn on the
faucet and drain completely the first tank of water.
(1) Shut off the system
Unplug power supply first, then turn off feed water adapter valve
(2) Call authorized service center or distributor. Before calling, please try your best to determine exactly
the problem you have encountered by referring to the “Troubleshooting” section.
(1) If you know you are not using the system for more than two weeks, shut off the system and drain
the stored water.
(2) Turn off feed water adapter valve.
(1) Turn on the feed water adapter valve.
(2) Plug in the power supply.
If you are not familiar with the appliance, please call your local service center or distributor for servicing.
(1) Follow the proper procedure to shut off the system.
(2) Use a housing wrench to open the housing. Make sure the Appliance always stands upright during filter
changes.
(3) Replace the correct cartridge, and tape the thread with Teflon type. Make sure the flow direction before
changing filter.
BRASS
BALL VALVE
O-RING FAUCET
1/2" PORT
FEED WATER
CONNECTOR
FEED WATER
INLET
Different installation method is used depending on the type of water
supply piping arrangement in your home.
(A) Undersink supply piping arrangement
(1) Turn off cold water valve or the main valve.
(2) Loosen nut at the top of riser.
(3) Install the feed water adapter valve.
(4) Reconnect the nut with cone washers to the feed water adapter.
(5) Connect 1/4" (or 3/8") tubing to the feed water adapter valve,
using compression nut, plastic sleeve and insert.
a) b) c)
(B) Wall mount mixer or faucet(option)
(1) Turn off water main valve. Remove the faucet.
(2) Install feed water adapter valve on the cold water side only.
(3) Install the extension piece on the hot water side.
(4) Reinstall the faucet.
BRASS
BALL VALVE
KITCHEN
FAUCET
FEED WATER CONNECTOR
3/4" PORT (option) (Hot water side)
(Cold water side)
FEED WATER
INLET
C Type Saddle Valve
Tubing
www.aquaprouae.com