Arc-Zone Sharpie DX A-PTGK-DHD User manual

Arc-Zone.com, Inc.
2091 Las Palmas Drive, Ste. F
Carlsbad, CA 92011-1551 - USA
Tel. [phone]
[email protected]
Copyright©2019, Arc-Zone.com®, Inc. All Rights Reserved
1 / 2
• v
SHARPIE HEAD KIT ASSEMBLY (Milwaukee cordless only)
installationinstallationguideguide
from
Insert Mandrel into collet. Leave a 1/16” (1.6mm) gap from the boom
of Mandrel shank. Depress lock buon on motor,
use 3/8”(9.5mm) open end wrench to ghten collet nut.
DO NOT OVER TIGHTEN
Remove ONLY the 2 side screws from Upper Housing using
the large allen wrench (included in kit) to
detach the Upper Housing from the Lower Housing
With the small allen wrench (included in kit), remove Mandrel Screw from
the Mandrel. Thread on Lower Housing and snug down fairly ght.
Align Sharpie logo with lock buon on motor.
Test run motor to ensure smooth operaon.
Step# 2
Step# 3
Step# 4
Step# 1
Install O-ring spacer to threads on motor.
“Screw” all the way down, ll contact is made to the base of motor.
NEXT PAGE

Arc-Zone.com, Inc.
2091 Las Palmas Drive, Ste. F
Carlsbad, CA 92011-1551 - USA
Tel. [phone]
[email protected]
Copyright©2019, Arc-Zone.com®, Inc. All Rights Reserved
2 / 2
Step# 5
Step# 6
Step# 7
Step# 8
Install Upper Housing press down to check the grinding wheel height. It should
be ush with the lower edge of the side window in the Housing.
(To adjust the Mandrel height, see step #2).
SHARPIE HEAD KIT ASSEMBLY (Milwaukee cordless only)
from
installationinstallationguideguide
Test run motor to ensure smooth operaon.
Congrats! Your new Sharpie Tungsten Grinder is ready to go.
Please be sure to use proper eye, ear and breathing protecon when in use.
Consult the Sharpie Operaons Manual before operang.
Thread in one side screw and leave loose.
Thread in 2nd side screw and ghten each screw evenly .
Install Grinding Wheel while pressing the motor sha lock buon on motor.