Archers Sleepcentre LPD STOCKHOLM User manual

1 Hour
LPD STOCKHOLM SINGLE BED
PLEASE KEEP THE ORIGINAL PACKAGING UNTIL THE ITEM IS FULLY ASSEMBLED AND IN PLACE.
IN THE UNLIKELY EVENT THAT YOU NEED TO RETURN YOUR PRODUCT, IT MUST BE RETURNED IN
ITS ORIGINAL PACKAGING TO AVOID FURTHER DAMAGE. FAILURE TO COMPLY TO THESE
PROCEDURES, NO RETURN'S WILL BE ACCEPTED.
Assembly Instructions - Please keep for future reference
1
Please check you have all parts listed on your assembly sheet. In the unlikely event that any parts are missing,
please contact your retailer immediately.
Do not use any other tools than those listed on your assembly sheet / tools provided.
Use of power tools could damage your product and returns would not be accepted back in these circumstances.
Use of power tools could also make your product unsafe due to overtightening.
Depending on the amount of use your product receives, it may be necessary to tighten the fixings from time to time.
Assemble your product on a soft surface to avoid scratching and also preferably in the room intended for use
to avoid having to move the product unnecessarily once assembled.
For cleaning please use a clean damp cloth or duster. Use of abrasive or chemical cleaners will most likely scratch
or damage the surface of your product. We do not accept returns for damages arising from incorrect care of products.
Please keep the original packing until your item is fully assembled and in place. In the unlikely event you need to return
your product. It must be returned back in its original packing to avoid any damage.
The surface of this item is not heat resistant. Please use a mat under hot, cold or wet items to prevent marking.
Important: Read carefully
" SHOULD IT BE NECESSARY TO RETURN THIS PRODUCT FOR ANY REASON,
IT MUST BE RETURNED IN ITS ORIGINAL PACKAGING"
If the product is going to be used on a wood, laminate or tiled floor, we would recommend the use of anti-slip pads, these
are available cheaply in most good hardware stores.
100CM
98.5CM
194CM

Exploded View
Components - Panels
Please check that you have all the components listed below before constructing your items.
K LEFT K RIGHT
I
I
JA
B
G
H
C
E
D
E
D
F
Parts No Description Qty
A Bed Side Panel - L 1
B Bed Side Panel - R 1
C Center Panel 1
D Side Support Panel 2
E Side Support Panel 2
F Bed End 1
G Center Support Panel 1
H Head of a Bed 1
I Bottom Panel - L/R 2
J Bottom Panel - Center 1
K Wooden Leg 2
2

CB Screw 4 x 38mm
23 units
(A) (B) (C) (D)
(E) (F) (G) (H)
(I) (J) (K) (L)
JCBC Screw 8 x 20mm
2 units
Double Cam Bolt
4 units
Cam Nut
22 units
Tapping Screw
#10 x 1/2
16 units
CB Screw 3.5 x 14mm
2 units
Tad Bracket 01
2 units
Allen Key M4
1 unit
Allen Key M5
1 unit
Cam Bolt
14 units
Wood Dowel 8 x 30mm
18 units
JCBCW 6 x 50mm
6 units
3
COmponents - Fixings
Please check that you have all the components listed below before constructing your items.
Note: The quantities below are the correct amount to complete the assembly. In some cases more fittings
may be supplied than are required.
Tools Required
Ruler - Use this to measure your screws (mm)

C x 10
C
E
Dx2
x2
A
B
4
Step 2
Step 1
Assembly Instructions
C x 8

F
AB
C
B
A
Step 4
Step 3
5
B x 14
J x 6

x2
x2
E
D
H x 2G x 2E x 2
H LEFT
K LEFT
E
G
H RIGHT
K RIGHT
E
G
G
E
L
J x 16
Step 6
Step 5
6

A
B
D
E
B
C
J
1st Step
2nd Step
B
C
J
1st Step
2nd Step
Step 8
Step 7
7

A
C
B
E
I
I
C
J
I
C
J
A
1st Step 2nd Step
1st Step 2nd Step 3th Step
Step 10
Step 9
8
C
I x 4
D

B
JJ
1st Step 2nd Step
A
C
B
F
B
K
KF
A
Step 12
Step 11
9
H
F
F x 16

A
C
C
B
H
G
Step 14
Step 13
10
D x 6
D
K
A x 5

B
I
I
J
Step 16
Step 15
11
A x 18