Argent EURA Installation guide

1. INSPECT ALL PARTS PRIOR TO INSTALLATION FOR
SUITABILITY AND/ OR DEFECTS
2. ANY SUSPECTED DEFECT SHOULD BE REPORTED AS
SOON AS POSSIBLE
3. SHOULD ANY PRODUCT BE INSTALLED DESPITE A FAULT
HAVING BEEN FOUND AND REPORTED, ARGENT WILL
NOT ACCEPT LIABILITY FOR THE COST OF LABOUR TO
REMOVE AND INSTALL ANY REPLACEMENT PRODUCT/S
BASIN MIXERS
NOTES PRIOR TO INSTALLATION
1. Please ensure pipework is clear of debris by ushing
lines prior to installation.
2. We recommend hot and cold water isolation stops are
used – not included in supply.
NOTES FOR INSTALLATION
1. Inlet pressure range 100 – 500kpa
2. Maximum hot water temperature 60 C
3. AS/NZS 3500 requires 500 kPa maximum operating
pressure at any outlet within a building
4. Hot & Cold inlets should have equalised water
pressures.
PRESSURE AND TEMPERATURE REQUIREMENTS
21008
ASNZ 3718
• Where the mixer is going into a stone or
laminate top, cut a 35mm ø hole.
STEP 1
• Install the allthread screw into the
bottom of the basin mixer.
• Install basin mixer sealing O ring &
ange(if supplied)
STEP 2
Please direct any
feedback for this product
to Customer Central:
support@customer-
central.com.au or call
1300 364 748
Eura Basin Mixers
Care & Installation Guide
Technical Hotline Customer Central [email protected]
1800 356 717 1300 364 748
EURA

BASIN MIXERS
• Feed the two hoses through the hole in
the basin or bench top and attach to
the basin mixer.
STEP 3
• Fit the rubber gasket and xing plate
into position under the basin/ bench
top, fasten with the nut.
STEP 4
• Make sure the hoses are connected to
the correct hot and cold water feed,
and then tighten the nut.
STEP 5
• Open the stop valves (not included in
supply), ush the lines, then close the
mixer lever and check there are no
leakages.
STEP 6
• TWISTING OR STRECHING THE FLEXIBLE
HOSES DURING INSTALLATION MAY
RESULT IN FAILURE, AND WILL VOID THE
WARRANTY.
• AVOID SEVERE BENDS IN THE FLEXIBLE
HOSES AS THIS MAY RESULT IN FAILURE
AND WILL VOID THE WARRANTY.
NOTES TO THE INSTALLER
• THE SPECIAL CHROME FINISH ONLY
REQUIRES CLEANING WITH MILD
HOUSEHOLD DETERGENT AND DRY WITH
A CLEAN COTTON CLOTH TO RETAIN ITS
LUSTROUS SHINE.
• AVOID CLEANING WITH ABRASIVE
MATERIALS OR CLEANERS
CLEANING AND MAINTENANCE
Hot on LHS
Cold on RHS
Hot on LHS
Cold on RHS
Technical Hotline Customer Central [email protected]
1800 356 717 1300 364 748
Eura Basin Mixers
Care & Installation Guide
EURA