Argent IN48905 Installation guide

Inlet valve water pressure
and pipe sizing must comply
with AS3500 & Manufacturers
Specification.
Maximum 500kpa static.
Minumum 100kpa dynamic.
Not suitable for low pressure
systems.
1. Inspect all parts prior to
installation for suitability and/or
defect.
2. Any suspected defect should
be reported as soon as
possible.
3. Should any product be installed
despite a fault having been
found and reported, liability will
not be accepted for the cost
of labour to remove and install
any replacement products.
IMPORTANT INSTALLATION NOTE:
Flush Plate Selection
IN48905
Disclaimer: Products in this specification manual must by regulation be installed by licensed and registered trade people. The manufacturer/distributor reserves the right
to vary specifications or delete models from their range without prior notification. Dimensions are nominal measurements only. Dimensions and set-outs listed are correct at
time of publication however the manufacturer/distributor takes no responsibility for printing errors.
In-Wall Cistern (Mechanical Activation)
Care & Installation Guide
ARGENT 80 IN WALL CISTERN & FRAME - MECHANICAL
RECOMMENDED FLUSH PLATES:
Kubic
Grace Round
WELS 4 Star / 3.5Lpm
WELS REG No. L05257
Edge
Customer Central
1300 364 748
[email protected]
www.argentaust.com.au

In-Wall Cistern (Mechanical Activation)
Care & Installation Guide
Customer Central
1300 364 748
[email protected]
www.argentaust.com.au
CISTERN & FRAME INSTALLATION

In-Wall Cistern (Mechanical Activation)
Care & Installation Guide
Customer Central
1300 364 748
[email protected]
www.argentaust.com.au

In-Wall Cistern (Mechanical Activation)
Care & Installation Guide
Customer Central
1300 364 748
[email protected]
www.argentaust.com.au

In-Wall Cistern (Mechanical Activation)
Care & Installation Guide
Customer Central
1300 364 748
[email protected]
www.argentaust.com.au

In-Wall Cistern (Mechanical Activation)
Care & Installation Guide
Customer Central
1300 364 748
[email protected]
www.argentaust.com.au

In-Wall Cistern (Mechanical Activation)
Care & Installation Guide
Customer Central
1300 364 748
[email protected]
www.argentaust.com.au
PAN INSTALLATION

In-Wall Cistern (Mechanical Activation)
Care & Installation Guide
Customer Central
1300 364 748
[email protected]
www.argentaust.com.au

In-Wall Cistern (Mechanical Activation)
Care & Installation Guide
Customer Central
1300 364 748
[email protected]
www.argentaust.com.au
1. Daily care will extend your Argent products lifespan. For the daily cleaning, we recommend
using a soft, non-abrasive sponge or cloth, like Microfiber cloths. (Tip: Dampen microfiber
cloths before use.)
2. If you wish to use a cleaning agent, it is reccomended to use a standard, general-purpose
cleaning agent.
3. Do not use any aggressive cleaning agents on this product. Aggressive cleaning agents like
scouring creams and powders, highly concentrated drain cleaning chemicals, special tap/
metal cleaning agents or bleeching agents containing chlorine will damage the product.
TROUBLE SHOOTING GUIDE:
CARE & CLEANING:
SPARE PARTS:
SAFETY NOTICE: TURN OFF WATER SUPPLY WHEN SERVICING ANY COMPONENTS
Symtom Possible Cause Corrective Action
No Flush Supply stop is closed Open the supply stop
Flush Plate not connected Check Flush Plate is connected
Flex hose is blocked or kinked Check flex hose
Water Leaking
into Pan
Outlet seal issue Check outlet valve seal and outlet valve
hosing, replace if required
Inlet valve water height too high Check water inlet height and adjust so it
is lower than overflow tube
Inlet seal leaking Check inlet seal and replace if damaged
Part # Code Description
5 2K1270-00-01 Gearing Bracket Complete
10 2K1161-A0-01 Tiling Template
12 K9100-G-1016 Cistern Stop
13 260107-5 Inlet Flex Hose
14 B3220-D Inlet Valve
15 K4030-G-1002 Outlet Valve
23 3K1248-A0-F6-Y In-Wall Flush Pipe Vertical
25 30990 O Ring Seal for Flush Pipe
27 2K723-00-01 In-Wall Flush Pipe Horizontal
28 30689-2 Key Seal