Argos 612/841 User manual

If you need help or have damaged or missing parts,call the Customer Helpline: Argos=08456 400800
Homebase=03450 778888
Issue 1 - 04/09/14

Safety and Care Advice
Important - Please read these instructions fully before starting assembly
1
Care and maintenance
Only clean using a damp cloth
and mild detergent, do not use
bleach or abrasive cleaners.
From time to time check that
there are no loose screws on
this 4-tier shelf.
This product should not be
discarded with household waste.
Take to your local authority waste
disposal centre.
• Check you have all the
components and tools listed on
the following pages.
• Remove all fittings from the
plastic bags and separate them
into their groups.
• Keep children and animals
away from the work area, small
parts could choke if swallowed.
• Make sure you have enough
space to layout the parts before
starting.
• During assembly do not stand
or put weight on the product,
this could cause damage.
• Assemble the item as close
to its final position (in the same
room) as possible.
• Assemble on a soft level
surface to avoid damaging the
unit or your floor.
• Parts of the assembly will be
easier with 2 people.
• To reduce
the likelihood of
damaging your
product please
ensure that your
power drill is set on a low torque
setting.
• Regularly check and ensure
that all bolts and fittings are
tightend properly.
Handy Hints

Components - Shelf
Please check you have all the fittings listed below
B
Components - Fittings
Please check you have all the fittings listed below
Note: The quantities below are the correct amount to complete the assembly. In some cases more
fittings may be supplied than are required.
Lower metal leg X 4
(2.5x 89 cm)
1Upper metal leg X4
(2.5x61cm)
3
Shelf X4 (35x90cm)
2
If you have damaged or missing components,
call the Customer Helpline:
C
B
Plastic stopper x 4
D
A
Feet x 4 Plastic locking caps x 32 Connector x 4
2
Argos=08456 400800
Homebase=03450 778888

Assembly Instructions
Step 1
Attaching plastic feet
Screw in feet into
lower metal leg as
shown in fig 1.
Step 2
Attaching stopper
Insert plastic stopper
into upper metal leg
Repeat for other 3
upper metal legs
3
A
1
A
1
fig 1
Repeat for other 3
lower metal legs
C
3
3
C
fig 2

Assembly Instructions
Step 3
Attaching shelf
Attach plastic caps
on to the lower metal leg
as shown in fig 3.
Slide down base shelf
until it locks over
plastic caps .
Push shelf firm to secure.
1
Step 4
Attaching shelf
Measure positon of
mid shelf required by
counting rings up from
base s
Connect with as
shown in fig 4.
helf.
Fit plastic caps
as shown in fig 4
Ensure all caps are fitted
to same height.
Slide down mid shelf
until it locks over
plastic caps
4
B
B
2
2
1
1
1
1
B
1B
B
B
D
2
1
B
1
1
11
2
B
D
fig 3
fig 4

Assembly Instructions
Step 5
Attaching upper
metal leg
Step 6
Attaching shelf
Fit top s and second helf
until they
lock ov er
plastic caps.
Push shelf firm to secure.
Screw uppermetal leg
to the connector
assembled in the lower
metal leg
as shown in fig 5.
3
1
1
1
1
3
3
3
3
2
2
BB
B
fig 5
fig 6
5
p
Attach lastic caps
to top ring of each leg .
B
1
top shelf

Assembly Instructions
Storage rack now fully
assembled.
Adjust feet for correct
level.
Warning:
Maximum safe loading:
55kgs per shelf
Step 7
Adjust feet
for correct level.
fig 7
6
If you need help or have damaged or missing parts,call the Customer Helpline: Argos=08456 400800
Homebase=03450 778888