ARH FREEWAYCAM3 User manual

FREEWAYCAM3 / SMARTCAM3 / SPEEDCAM3
DIGITAL (IP) LPR CAMERA
QUICK INSTALL GUIDE
Document Version: 2018.02.15
Please note that this is only a quick installation guide. For detailed
information see the full installation guide (see the link on the back side)
1INSTALLING THE HARDWARE
1.1 Remove protective film from the front of the camera.
1.2 Adjust the bracket by loosening the camera fastening screw on the bottom of the bracket
(with a size 5 Allen key). After the desired position is set, fasten the screw on the bottom.
Do not overtighten the screws. Failures due to inappropriate installation void the
warranty.
1.3 Connect the cables to the designated connectors. Seal the unused cable endings with end
sleeves before connecting to power!
Use smooth circular, quality, outdoor-certified cables. Improper cabling voids the
warranty!
Power
12 pin I/O
Ethernet
8 pin I/O
GPS*
GSM*
*in case of six connectors
1.4 Make sure the connecting cable does not lead rainwater drops into the camera housing.
1.5 Connect the camera to a computer or network switch, then power on the camera. The red
and green status LEDs on the camera front should stay on during the booting. After
finished, the green status LED flashes two times while the red one turns off signaling that
the camera is ready for operation.
!
!
!
!

2ACCESSING THE CAMERA
2.1 Make sure that the camera and the computer are connected to the same network.
2.2 Enter an alternate IP address or set your computer’s IP in the 192.0.2.x subnet, where x is
an integer between 1 and 254 except 3. Set the subnet mask to 255.255.255.0.
2.3 Start a browser then enter http://192.0.2.3 address into the address bar. This is the
camera’s default IP address.
3TROUBLESHOOTING
3.1 If you have any questions or difficulties, see the see the full Installation Guide first.
3.2 There is a sticker indicating the Name, IP address, MAC address and the Serial Number of
the camera. The sticker can be found on the back of the device, under the sunshield.
3.3 To enter the Recovery mode, power off the camera first then hold a magnet
(recommended strength: 1210 mT) on the indicated position, under the shield (see the
figure below). Power on the camera and wait 5 seconds. Now remove the magnet and
reach the camera via its default IP address.
AVAILABLE MANUALS AND GUIDES:
MANUAL AND HELP
PROGRAMMERS GUIDE
CAMERA SETUP 24/7
USER’S GUIDE
INSTALL GUIDE
www.arh.hu/xuasd
www.arh.hu/xuasd
www.arh.hu/xuasd
www.arh.hu/xuasd
CONTACT INFORMATION
ARH Technical Support: https://www.arh.hu/index.php/en/support.html
Headquarters:
ARH Inc.
Alkotás utca 41
HU-1123 Budapest
Hungary
Phone: [phone]
Fax: [phone]
Web: www.arh.hu
ARH America:
ARH America Corp.
28059 US Highway 19 North
Suite 203
Clearwater, FL 33761
Phone: [phone]
Fax: [phone]
Web:
www.adaptiverecognition.com
Service Address:
ARH Inc.
Ipari Park HRSZ 1113/1
HU-2074 Perbál
Hungary
Phone: [phone]
E-mail: [e-mail]
!
!