Arkuz BlueNet Power+ User manual

Arkuz BlueNet Power+
Device Installation Guide

Contents
Arkuz BlueNet Power+
Product Contents.
Typical Electrical
Connections.
Connecting Arkuz BlueNet
Power+ device to your
Electrical Loads.
Your connections to Electrical
Load powered by Arkuz
BlueNet Power+ device.

Arkuz BlueNet Power+
Product Content
Arkuz BlueNet Timer Module.
The BlueNet Power+ module has
Wire set 1: 2 RED wires of
2.5mm gauge for Input Supply
and a GREEN wire of 0.75 mm
gauge for Earthing.
Wire set 2: 2 BLACK wires of
2.5mm gauge for Output Load
and a GREEN wire of 0.75 mm
gauge for Earthing.
Wire set 3: 2 BLUE wires of .
0.75mm gauge for regular loads.

Typical Electrical Connections
110/220 Volt AC
SUPPLY (LINE,
NEUTRAL & EARTH).
Load is connected to
the switch through a
voltage stabiliser
SUPPLY
WALL SOCKET
LOAD

Connecting Arkuz BlueNet Power+
device to your Electrical Loads
Items Required
Arkuz Smart BlueNet
Timer
Screw Driver
Electric Wire
Duct Tape

Step 1
Make sure all power
to the wall socket/
load is turned to OFF
position.
The installation deals with High Voltage AC
current hence take at most caution while
installing the Arkuz BlueNet Power+system. It is
highly recommended that any electricity coming
to the switchboard panel where the smart light
controller is being installed is switched off before
starting the installation and be turned back on
only after the installation is complete.
Connecting Arkuz BlueNet Power+
device to your Electrical Loads
SUPPLY
WALL SOCKET
LOAD

Step 2
Disconnect Connections
between Volgate Stabiliser
and the Load.
In case Voltage stabilizer in
not used then the
connection between the
wall socket and the Load
should be disconnected
Connecting Arkuz BlueNet Power+
device to your Electrical Loads
SUPPLY
WALL SOCKET
LOAD

Step 3
Connect the RED set of wires of
Arkuz BlueNet Power+device to
the Supply side LINE & NEUTRAL.
Connect the BLACK wire of
Arkuz BlueNet Power+device to
Load
The GREEN wire of Arkuz BlueNet
Power
+
device need to be
connected to the Earth wire of the
socket on the Input side and on
the Load on the output side.
The BLUE
SUPPLY
WALL SOCKET
LOAD
Connecting Arkuz BlueNet Power+
device to your Electrical Loads

Your connections to Electrical Load
powered by Arkuz BlueNet Power+ device
SUPPLY
WALL SOCKET
LOAD

Arkuz Technologies
beyond possibilities