Arlec HL8 User manual

WARRANTY
CPIN002108
*
ASSEMBLY AND INSTRUCTIONS
PORTABLE HALOGEN
FLOODLIGHT
HL8
150W
© This instruction leaflet is subject to copyright and must not be reproduced,
copied or otherwise used in any way or for any purpose without the consent in
writing of the owner, Arlec Australia Pty Ltd (A.C.N. 009 322 105).
CPIN002108
Arlec guarantees this product in accordance with the Australian Consumer Law.
Arlec also warrants to the original first purchaser of this product (“you”) from a retailer that this product
will be free of defects in materials and workmanship for a period of 12 months from the date of purchase;
provided the product is not used other than for the purpose, or in a manner not within the scope of the
recommendations and limitations, specified by Arlec, is new and not damaged at the time of purchase, has
not been subjected to abuse, misuse, neglect or damage, has not been modified or repaired without the
approval of Arlec and has not been used for commercial purposes (“Warranty”).
If you wish to claim on the Warranty, you must, at your own expense, return the product, and provide
proof of original purchase and your name, address and telephone number, to Arlec at the address below or
the retailer from whom you originally purchased the product within 12 months from the date of purchase.
Arlec will (or authorise the retailer to) assess any claim you may make on the Warranty in the above manner
and if, in Arlec’s reasonable opinion, the Warranty applies, Arlec will at its own option and expense (or
authorise the retailer to) replace the product with the same or similar product or repair the product and
return it to you or refund the price you paid for the product. Arlec will bear its own expenses of doing
those things, and you must bear any other expenses of claiming on the Warranty.
The Warranty is in addition to other rights and remedies you may have under a law in relation to the
product to which the Warranty relates.
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law.
You are entitled to a replacement or refund for a major failure and for compensation for any other
reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the
goods fail to be of acceptable quality and the failure does not amount to a major failure.
Arlec Australia Pty. Ltd. ACN 009 322 105 (“Arlec”) gives the Warranty.
Arlec’s telephone number, address and email address are:
Customer Service: [phone]
Building 3, 31 – 41 Joseph Street, Blackburn North, Victoria, 3130
Blackburn North LPO, P.O. Box 1065, Blackburn North, 3130
Email: [email protected]
HL8_CPIN002108.indd 1 8/10/12 3:19 PM

PORTABLE HALOGEN FLOODLIGHT (HL8)
ASSEMBLY
DO’S AND DON’TS
Extreme care should be taken when handling and operating the
Portable Halogen Floodlight HL8. Please observe the following do’s
and don’ts to ensure safe and trouble free use:
DO ensure combustible material is kept away from Floodlight.
DO use the handle to adjust the beam.
DO keep the floodlight out of reach of children when in use.
DO switch off and allow to cool for a minimum of 10 minutes before
storing.
DO take extreme care in crowded or confined areas that Floodlight is
not positioned where it can be easily toppled over.
DO use the Floodlights in horizontal position (±4°). If not used in
horizontal position the tube life will be greatly reduced.
DON’T touch tube with bare hands. This could cause tube to shatter
when Floodlight is switched on.
DON’T stand Floodlight in pools of water.
DON’T handle with wet hands or operate when standing on wet
surface.
DON’T position the Floodlight closer than one metre from surface to
be illuminated.
DON’T allow power cable to come into contact with front of Floodlight
or housing.
DON’T touch the housing or glass while hot.
DON’T allow overhanging shrubs or foliage to come into contact with
Floodlight.
DON’T place or operate the Floodlight closer than 5 metres to a
swimming pool or spa.
DON’T operate the Floodlight with the front of housing opened.
OPERATION: The Portable Halogen Floodlight HL8 is suitable for
indoor or temporary outdoor use, from any standard power point and is
weatherproof to IP44
Assemble stand and light as
follows: Attach stand (A) to
floodlight / handle assembly (B)
using adjustment knob (C).
Tighten to thumb pressure,
do not over tighten.
NOTE: Arlec safety adjustment
slot prevents Floodlight from
tilting too far forward or
backward. This helps avoid
accidental scorching or burning.
Replacement Arlec 150 Watt
(79mm) Linear Tungsten
Halogen Tube available from
most leading hardware stores.
Arlec Part No HT150.
The tungsten halogen tube is supplied and packed separately to avoid
damage. Open the Floodlight housing by loosening the top screw. The
glass front of the housing will hinge forward and down. Ensure that
Floodlight is unplugged from wall socket. Insert the tube in the holder,
ensuring that you do not touch the glass envelope of the tube with bare
hands. Use the tube wrapper to handle tube. (Oils from the hands can
cause the tube to fail or shatter).
If necessary the tube should be carefully cleaned with methylated spirit
and dried before installation. Do not attempt to adjust or force the tube
holder with tools, but carefully push the tube into the holder contacts.
Reassemble the Floodlight housing.
4°
4°
4°
4°
FITTING THE TUNGSTEN HALOGEN TUBE
A
B
C
HL8_CPIN002108.indd 2 8/10/12 3:19 PM