ARMAC MARTIN MOS/BRKT/190/BEL Instruction sheet

0121 359 2111 | armacmarn.co.uk | sales@armacmarn.co.uk
How to install your Shelf Bracket
We recommend using a qualied tradesman for installaon.
Contents
Wall plugs - x2
Shelf Bracket - x1
No 6 x 19 screws - x2
Plugs (for use when not xing shelf
with screws) - x2
No 10 x 50 screws - x2
Tools required
- Appropriate safety equipment i:e safety glasses
- Spirit level
- Drill
- Screwdriver
- Tape measure
- Pencil

Step One -Safety
Use a wire/pipe power detector to ensure that there are no electrical cables
or water pipes where you intend to posion the shelf.
Use a tape measure and spirit-level to mark the vercal posion for your
shelf bracket with a pencil. Your mark should be for the top of the shelf
bracket and boom of the shelf bracket.
Step Two -Vertical positioning of your shelves
Use the spirit level and a pencil to draw a perfectly horizontal line along the
area of the wall where you intend to mount the shelf. If your spirit level has
a measure on it, draw the line to the full length of the shelf. If not, use a tape
measure and redraw the line a couple of mes, unl it is the same length of
the shelf.
Step Three -Draw a level line
Decide where to posion the brackets and mark these posions on your
horizontal line. Focusing on one bracket at a me, place the top of the
bracket up to horizontal line and centre on your posioning mark. Keeping
the bracket perfectly sll, use a pencil to mark the screw holes on the wall.
Repeat this for each of the brackets.
Step Four -Mark positions for the shelf brackets

Step Six -Insert wall plugs
Insert the wall plugs into the drilled holes. Ensure that the wall plugs are fully
inserted and they all sit ush to the wall – tap gently with a hammer if
necessary. If any of your wall plugs are scking out, they will prevent your
bracket from sing ush to the wall when mounted.
Drill into the walls at the centre point of all your screwhole markings. Drill
the holes deep enough in to the wall to fully accommodate the wall plugs.
Step Five -Drill into the wall
Screw shelf brackets to the wall using a screwdriver and No 10 x 50
countersunk screws.
Step Seven -Fix shelf brackets to the wall
Diameter 8mm drill

Finish Care & Cleaning
Thank you for purchasing your brass shelf bracket from Armac
Marn. Our products are of the nest quality and hand nished.
Please follow the below care guide to maintain the
condion of the product.
Wipe your product down with a so dry cloth at regular intervals
Do not use abrasive cleaners, ammoniated products, rubbing
alcohol, detergents, astringents, bleach based cleaners, aggressive
chemicals, abrasive cleaning pads, or harsh polishes on the
product.
Posion shelf to the supporng brackets and ensure it is level, sing central
on the brackets. Use a screwdriver and No 6 x 19 countersunk screws to x
brackets to the underside of shelf. Alternavely, t plugs provided should
you wish to bond a shelf to the bracket.
Step Eight -Fix shelf to brackets
2 plugs for use when not
xing shelf with screws