AromaTech AroMini User manual

AroMini
AromaTech Scenting Solutions
Product Manual
For information or support please contact us at +1.888.276.6245 or [e-mail]

Thank you for purchasing the AroMini Scent Machine. We hope you enjoy using it with your choice of
aroma oil.
Please read this manual carefully before operating this scent machine. It’s proper use will prolong the life
of your product.
Do not use the power chord if it is damaged.
Do not try to open the scent machine or x it by your self. In case of a technical issue please contact
us for further assistance at +1.888.276.6245.
In case of lightning or thunder, please do not touch the power suply cable.
The following instructions will show you how to properly operate your scent machine to achieve the
utlimate ambiance.
Enjoy!

Specications
Model AroMini
Dimensions 285mm x 64mm
Supply DC12V
Total Power 3W
Coverage Area 1,000 sq.ft.
Warranty Card
Product
Manual
What’s inside the box!
Product ManualPower Supply Chord
AroMini Empty Bottle

How to Operate the AroMini.
Locking point inside the diuser
Power chord socket
Bottom part of the diuser Top part of the diuser Empty bottle Power chord
Scenting point
Connect the top
part with the
bottom and and
turn to lock
1. Take the unit out of the box.

How to install the bottle with aroma oil.
Figure 1 Figure 2
Put the tube inside
the fragrance bottle
Fixed fragrance bottle
Figure 3
Figure 4
Figure 5
Insert the
bottle into the
bottom part
Align the connectors
Once alined press rmly and rotate
clockwise to lock and snap into place.
Power outlet
Insert the power chord
Intensity dial
Turn the bottle counter-
clockwise to tighten.

How to operate the AroMini.
Now that you’ve inserted the fragrance bottle into the diuser and locked the top
and bottom part together, go ahead and plug in the power chord into the wall
outlet. Once connected the green light on the adaptor will lit up to indicate the unit
is powered on.
The dial will allow you to control the intensity of the fragrance output. Turning the
dial all the way down, counterclockwise, will shut it o completely.
Please note the unit works on an interval, 300 sec. ON and 30 sec. OFF. Don’t be
alarmed if the AroMini stops working, it will only be for 30 seconds. This will ensure
you get even scent distributtion and prolong the life of the scent diuser.
Concentration increased from to (yellow being the lowest and red the highest).
Intensity Dial

Care Instructions.
Once the fragrance bottle is installed do
not tilt it or lay the unit on its side as that
will result in oil spillage and damage to
the scent machine.
Cleaning the AroMini.
To avoid cross contamination when
changing aromas, please use rubbing
alcohol to clean the machine. To do so
pour rubbing alcohol into an empty
bottle, screw the bottle into the
diuser and run it for 5-10 minutes. Rubbing alcohol Run it through the
unit for 5-10 min

Issue Solution
Not diusing aroma.
Pump doesn’t work.
Check the unit is turned ON.
If the pump isn’t working, replace the pump
Small amount of fragrance
comming out.
Atomizing head is clogged. Run rubbing
alcohol through the unit.
Diuser spraying liquid. Unit is tilted. Note, that residue may occur
around the head of the neubulizer.
Oil spilled at the bottom
of the diuser. Fragrance bottle is loose. Tighten the bottle.
Abnormal pump sound Pump is loose. Replace pump.
All products are covered under 1 year manufacturers warranty.
For any issues or concerns please contact us at +1.888.276.6245 or
[e-mail] and we would be happy to assist you.