Copenhagen Blind Wall Controller
Productno: AACPH-RC1-EU
The Wall Controller is a multi-
function button which is able to
control the position of a blind and switch appliances on/off. The
Wall Controller consists of a wall bracket and a
The portable controller has an integrated magnet which
user the possibility to place it
in the wall bracket or on any metallic
surface. This product can be included and operated in any Z
Wave
TM
network with other Z-Wave
TM
certified devices from other
manufacturers and/or other applications.
The rotation function
to control position of blind works when
is fitted upright or stick on the wall
situations the controller will work only
Please provide a 5 D C voltage through Micro USB Port to
wake the device up before the first using.
1
Copenhagen Blind Wall Controller
function button which is able to
control the position of a blind and switch appliances on/off. The
The portable controller has an integrated magnet which
in the wall bracket or on any metallic
surface. This product can be included and operated in any Z
certified devices from other
to control position of blind works when
is fitted upright or stick on the wall
Please provide a 5 D C voltage through Micro USB Port to
using Network Wide Inclusion)
primary controller in inclusion mode then p
The LED pointer will flash red up to 30 seconds while it waits
to be included. When successfully included it will turn on a green
surround light for 1 second.
Manual inclusion:(add
using Network Wide Inclusion)
primary controller in inclusion mode
pointer to area A (shown in Fig. 1) and
three times within 1.5 seconds.
will flash red up to 30 seconds while it waits to be included. When
successfully included it will tu
second.
Exclusion:(remove)
Set the primary controller in exclusion mode.
With the wall controller vertical p
utton three times within 1.5 seconds.
pointer will flash red once. When successfully excluded it
a 30 seconds auto inclusion mode
With the wall controller vertical point the
pointer to area A then press the
seconds and hold at fourth. The red LED
seconds release the button within 2 seconds while the LED goes
out. The LED will flash for 1 second if reset succeed
flash once if not succeeded.
Note:
Use this procedure only in the event that the primary
using Network Wide Inclusion)
primary controller in inclusion mode then p
The LED pointer will flash red up to 30 seconds while it waits
to be included. When successfully included it will turn on a green
using Network Wide Inclusion)
primary controller in inclusion mode
. With the wall controller
pointer to area A (shown in Fig. 1) and
three times within 1.5 seconds.
will flash red up to 30 seconds while it waits to be included. When
rn on a green surround light for 1
Set the primary controller in exclusion mode.
With the wall controller vertical p
oint the LED pointer to area A
utton three times within 1.5 seconds.
pointer will flash red once. When successfully excluded it
a 30 seconds auto inclusion mode
and the LED pointer will flash
With the wall controller vertical point the
pointer to area A then press the
Button four times within 2
seconds and hold at fourth. The red LED
seconds release the button within 2 seconds while the LED goes
out. The LED will flash for 1 second if reset succeed
Use this procedure only in the event that the primary
