Est. Melbourne 2014artefactindustries.com Product of Australia
WHERE AESTHETICS
MEETS PERFORMANCE
Feed low voltage cabling through ceiling access hole
& bracket. Connect wires from driver to the light tting.
Ensure that polarity is correct: RED (+) & BLACK (-)
DETAILS LISTED IN THIS DOCUMENT ARE SUBJECT TO CHANGE WITHOUT NOTICE . PLEASE GO TO WEBSITE FOR UPDATED INFORMATION
Mount bracket to ceiling at cable exit point. *NOTE:
Installer to supply screw xings which are suitable
for the mounting substrate and also the weight of the
light tting.
6
5
34To corresponding terminals marked on driver: Connect
DALI control wires; BLUE (+), WHITE (-). Connect low-
voltage wiring; RED (+), BLACK (-). Then insert driver
through hole cut in previous step.
Cut access hole in ceiling substrate, ensuring cut-
out is just large enough to t both driver and wiring.
Connect 230/240VAC wiring to corresponding
terminals marked on driver: BROWN (Live), BLUE
(Neutral).
2x
LOW VOLTAGE WIRES
TO LIGHT FITTING DALI CONTROL WIRES
Live
Neutral
(-) Negative
(+) Positive (-) Negative
(+) Positive
