Artemis LiFePO4-100BT User manual

User Manual Artemis LiFePO4-100BT
Thank you for choosing Artemis product. You can be sure that the product you have purchased is one of the best in
the market. Before using, please read this manual carefully and keep it for further reference.
LiFePo -100BT is a Lithium Iron Phosphate (LiFePo ) 12.8V100Ah rechargeable battery with Bluetooth function. It is
designed and manufactured for deep cycle use as power for caravans, motor-homes, electrical vehicle, renewable
energy storage systems, micro-grid and off-grid system, UPS, on boats etc.
Part 1 ．
．．
． Basic introduction
Battery Type LiFePO
No
m
inal
V
o
lta
g
e
12.8
V
Nominal Capacity 25
℃ /0.2C 100Ah
Energy 25
℃ /0.2C
1280
Wh
Dimension
Length 330
± 2mm (13.00inch)
Width 172
± 2mm (6.77inch)
Height 216
± 2mm (8.50inch)
Total height 216
± 2mm (8.50inch)
Net W
eight
About 11.6Kg
Internal Resistance (Fully Charged, 25 ℃ )
≤ 20m
Ω
Cycle life @25 ℃
0.2C/100%DOD
≥
2500 cycles
0.2C/80%DOD
≥
3500 cycles
Charging Current 20~100A, best: 20-50A
Max Charging Voltage
1 .6V
Standard Charge
Constant current 20A charge to 1 .6V, then
constant voltage 1 .6V charge till current drops
Max Discharging Current ( Continue)
100
A
Max Discharging Current
(Pulse)
2 0
A/3
seconds
Discharge Cut-Off Voltage 8. V
Operating
Temperature
R
ange
Discha
r
ge
-20 ℃～ 60 ℃ (-
℉～ 1 0 ℉ )
Cha
r
ge
0 ℃～ 5 ℃ (32 ℉～ 113 ℉ )
S
torage
-20 ℃～ 5 ℃ (- ℉～ 122 ℉ )
Terminal Type M8

Electronic characteristic
N.O Item S ecification
1 Over voltage detection value of charge 3.65 ± 0.10V
2 Over voltage detection delay time of charge 2000±1000mS
3 Release voltage of over charge 3.50 ± 0.10V
Max continuous charge current ≤100A
5 Over voltage detection value of discharge 2.50 ± 0.10V
6 Over voltage detection delay time of discharge 2000±1000mS
7 Release voltage of over discharge 3.00 ± 0.10V
8 Max continuous discharge current ≤100A
9 Over current detection value of discharge 110 ± 5A
10 Over current protection delay time of discharge 10000±2000mS
11 Discharging temperature protection 65±5
℃
12 Discharging temperature protection release 60±5
℃
13 Short circuit protection ≤600uS
1 Balance triggered Voltage 3. 0 ± 0.10V
15 Balance current 10~100mA
16 Internal impedance ≤60m
Ω
17 Current consumption @sleep mode ≤100uA
Part 2. Bluetooth APP
First download APP from the APP Store. From the APP, you will be able to access the basic battery information, such
as SOC (State Of Charge), Battery Voltage, Battery Temperature, the Input and Output Current (how much current is
going into the battery and how much current is going out of the battery), (@discharge mode) Time To Go (the time

your battery will last at present current output), (@charge mode) Charge time (the time needed to fully charge the
battery), and Charge/Discharge Switch (direct control of charge/discharge process).
Part 3 ．
．．
． Attention of o eration
Charge ：
1. The battery pack must be charged with a special charger for lithium batteries. When charging the battery, please
make sure that the power supply voltage is consistent with the input voltage of the charger, and the output voltage
of the charger is consistent with the battery’s charging voltage. Unqualified chargers will lead to battery failure or
short life.
2. The charging position shall be well ventilated. Do not charge in high temperature environment, and keep away
from inflammable and explosive gases or objects. The charger and battery shall be well placed to prevent from
falling.
3. It is normal that the surface of the battery box is slightly heated during charging. If it is found that the surface
temperature of the battery box is too high, the power should be cut off immediately for further check.
. After full charge, unplug the charger in time, and then disconnect the charger and battery interface. This process
cannot be operated in reverse.
5. When the battery leaves the factory, the SOC is about 0% - 60%, which needs to be supplemented before use.
6. Do not directly connect positive and negative ports, which will hurt yourself or damage the battery.
7. The maximum charging time should be less than than 12 hours (the specific charging time depends on the use of
the battery. Do not charge for long time.
O eration ：
：：
：
1. The battery can only be used for the intended purpose, not for other purposes.
2. The battery should be firmly installed in the vehicle/ vessel, so as to avoid the battery damage due to bumps
during the operation.
3. Do not use the battery in a wet environment
. Do not immerse the battery in water.
5. At normal temperature, the discharge performance of the battery is better, and at low temperature, the capacity
of the battery will decrease, so when the usage temperature is low, the working time of the battery after charging
will be reduced. This is normal.
6. The battery shall be placed in a place free from direct sunlight and radiation source, and the distance from the
heat source (fire source, heating, equipment, etc.) shall not be less than 2 meters.
7. Try to avoid using the battery in the place with strong static electricity. Static electricity can easily damage the
charging protection plate, resulting in abnormal operation of the battery.

8. If abnormal phenomena such as peculiar smell are found in the charging or discharging. Please stop use
immediately for further investigation.
9. Keep children away from the battery.
Battery Assembly
LiFePo -100BT supports further connection in series (max sets) or in parallel (max sets), respecting the
permitted configuration shown in the table below.
Connection 1S (12V) 2S (24V) 3S (36V) 4S (48V)
1P YES YES YES YES
2P YES YES YES YES
3P YES YES NO NO
4P YES YES NO NO
Note: xP means x batteries in parallel, and xS means x batteries in series.
WARNING:
1. Series/ arallel connection MUST be carried out by rofessional ersonnel, otherwise it may destroy the battery
or even cause danger to the o erator.
2. Before assembly, each battery MUST be fully charged and the voltage difference between batteries MUST be
≤
≤≤
≤ 0.1V.
3. ONLY use NEW batteries for further assembly.
4. ONLY use batteries of SAME model and SAME batch for further assembly.
Part 4 ．
．．
． Danger warning
1.Do not disassemble the battery!
2.Do not short circuit the battery!
3.Do not use battery in water or in liquid!
Part 5 ．
．．
． Trans ortation and storage
Trans ortation:
1. Battery transportation temperature: 20 ~ 30 ℃ .
2. Batteries shall be well packed in solid boxes for transportation.
3. During transportation, the battery shall not be subject to severe vibration, impact, exposure, inversion and
heavy pressure. Special attention shall be paid to waterproof.
. The battery shall be handled with care during loading and unloading. Throwing, rolling, heavy pressing and

dumping of battery are strictly prohibited.
Storage:
1. Store the battery in a cool and well ventilated area with low humidity, suggested storage temperature
-20 ℃～ 5 ℃ .
2. When the battery is not used for a long time (more than 3 months), please remove it from the device, charge
the battery to the semi saturated state.
3. Fully charge the battery every 3 months.
Part 6 ．
．．
． Ty ical faults and troubleshooting
Part 7 ．
．．
． Precautions for handling abnormal roblems
1. This product should be repaired by professional personnel. If you open the battery shell, it will void the warranty.
2. If the battery is seriously impacted, squeezed, dropped or heated, please stop use for further inspection or
Fault
henomenon
Reason Processing method
Unable to
charge
normally
Charger not plugged in
Charger fault
The terminal is dirty or the screw is not
locked
Protection board protection
Battery circuit fault
Check charger connector
Replace charger
Clean the terminals and lock the screws
Disconnect the battery for 30 seconds and
reconnect
Please contact the nearest dealer for repair.
Abnormal
discharge
Polarity error
The battery SOC is too low
Battery circuit fault
Check polarity
Charging first
Please contact the nearest dealer for repair.
Abnormal
discharge stop
Operation temperature too high, trigger
over temperature protection
Excessive discharge current, triggers over
current protection
External short circuit of battery, triggering
short circuit protection
Half an hour at room temperature
Reduce discharge current
Turn off the device, disconnect the battery, remove
the short circuit and then turn on the device

contact the agent or after-sales service office in time.
3. In case of fire, it is recommended to cover it with sand or thick wetted cloth, then use water to extinguish the fire.
If it is particularly urgent, you can also directly use a large amount of water to extinguish the fire.
. Although the used batteries do not have any pollution to the environment, disassembly of the used batteries has
certain risks. For safety, it is recommended to send to special waste battery disposal place or contact us for further
process.
Part 8 ．
．．
． Maintenance and after sales
1. According to the relevant laws and regulations of the country, Artemis will carry out warranty for the sold
products.
2. When your battery needs to be repaired, please bring the purchase battery invoice and warranty card to our
company or the dealer's designated after-sales service station for repair.
3. Failure caused by unauthorized disassemble and assembly, unauthorized maintenance or improper operation will
not be covered by the warranty.
. Faults and losses caused by charging, using, maintaining, storing and transporting not in accordance with the
requirements of this manual will not be in the scope of warranty and liability.
Part 9 ．
．．
． Others
1. For the safety, please read this manual in detail when using the battery.
2. Please keep this manual properly. If it is lost, it will not be reissued.
3. The company will not bear any legal liability for direct and indirect losses caused by improper use.
. In case of any direct or indirect loss caused by the user's inability to use the product for any reason, the company
shall only bear the responsibilities required by the applicable laws of the country.
5. If there is any difference between the actual product and the instruction manual due to the continuous technical
and appearance transformation of the product, the actual product shall prevail.
6. The company reserves the right to interpret the specification.
7. The company reserves the right to modify this manual without prior notice.

Part 10 ．
．．
． Warranty Certification
5 years limited warranty from the date of urchase
Year Charge of Re lacement
1 free
2 free
3 0%
60%
5 80%
Such services are only valid through an authorized service center. The warranty is valid on condition that the product
has been handled in accordance with the manual instructions and has not been repaired and/or tampered with by
non-authorized personnel and/or if the serial number has not been altered.
We suggest you keep the original packaging in case you have any reason to return your purchase to an authorized
service center.
Please return the product together with filled warranty card (not doing so will void any warranty), along with a
detailed description of device malfunction.
In addition, please note that the warranty does not cover products which have been modified or adapted for the
reception of transmission outside of the country for which such products have been designed and built, approved
and/or authorized or any damage caused by such modifications. If the product does not operate correctly or is it any
way faulty, please contact one of the authorized service centers located around New Zeland.
After-sale service center
A ollo Entertainment Limited
Add: 25D Karepiro Drive, Whangaparaoa, Auckland, 0932
web ： www.apollotv.co.nz tel ： [phone]
Email: [e-mail]

Warranty record card
Model ：
：：
： Product Descri tion:
Serial number: Date of urchase
：
：：
：
User name ：
：：
： Tele hone number ：
：：
：
Address ：
：：
： Postal code ：
：：
：
Dealer ：
：：
： Tele hone number ：
：：
：
Dealer address ：
：：
： Postal code ：
：：
：
Maintenance record
Date of re air Faults and maintenance Maintenance date Re airman