
8
User Manual AFGR935B
5. If the power supply cord (the cord with plug) is damaged, this
cord shall be replaced by the manufacturer or its service agent or an
equally qualified personnel to prevent a hazardous situation.
6. Never wash the product by spraying or pouring water on it! There
is a risk of electrocution.
7. WARNING: To avoid electric shock, ensure that the
device circuit is open before changing the lamp.
8. WARNING: Cut off all supply circuit connections before accessing
the terminals.
9. WARNING: If the surface is cracked, turn off the appliance to
avoid risk of electric shock.
10. Do not use cut or damaged cords or extension cords other than
the original cord.
11. Make sure that there is no liquid or humidity in the outlet where
the product plug is installed.
12. The rear surface of the oven also heats up when the oven is
operated. Electrical connections shall not touch the rear surface,
otherwise the connections may be damaged.
13. Do not tighten the connecting cables to the oven door and do not
run them over hot surfaces. If the cord melts, this may cause the
oven to short circuit and even a fire.
14. Unplug the unit during installation, maintenance, cleaning and
repair.
15. If the power supply cable is damaged, it must be replaced by its
manufacturer or authorized technical service or any other personnel
qualified at the same level, in order to avoid any dangerous situation.
16. Make sure the plug is inserted firmly into wall socket to avoid
sparks.
17. Do not use steam cleaners for cleaning the appliance, otherwise
electric shock may occur.
18. An omni-polar switch capable to disconnect power supply is
required for installation. Disconnection from power supply shall be
provided with a switch or an integrated fuse installed on fixed power
supply according to building code.
19. Appliance is equipped with a type ‘’Y’’ cord cable.