Ascension SY-HVA-350-SL User manual
Range Hood Ventilator
Instruction Manual
READ AND SAVE THESE INSTRUCTIONS
Copyright © 2016 Castlewood by AMS, All rights reserved.
SY-HVA-350-SL
To All Consumers:
Following the recommendations contained in this Instruction Manual will ensure this
CONTENTS:
RECOMMENDATIONS AND SUGGESTIONS
CHARACTERISTICS
INSTALLATION & USE
MAINTENANCE
RECOMMEDATIONS AND SUGGESTIONS
INSTALLATION:
* The manufacturer will not be held liable for any damages resulting from
incorrect or improper installation.
* Please read this entire instruction manual before installing and using this ventilation unit. Keep this
instruction manual in a safe place for future reference.
* This ventilation unit can be used in the Ducted or Ductless modes.
regarding this unit.
ventilator unit.
clean air.
NOTICE:
Two or more people are required to install or move this appliance. Failure to do so could cause physical
injuries.
USE:
* Never use the ventilator for purposes other than what it has been designed for.
not engulf the pan/pot sides.
* The ventiltaor should not be used by children or persons not instructed in its proper use.
1
MAINTENANCE:
* Clean the ventilator unit using a damp cloth and a neutral liquid detergent.
* DISPOSAL: Do not dispose of this product as unsorted municipal waste.
Conduct collection and disposal of this unit according to local code.
WARNING!!!
In certain circumstances electrical appliances may be a hazard.
* Do not touch the light bulbs after appliance use.
* Do not disconnect the appliance with wet hands.
* Disconnect the electrical plug prior to any maintenance.
under supervision of adults and out of the reach of children.
* Do not use the unit outdoors.
instruction, concerning use of the appliance by a person responsible for their safety. Children should be
supervised to ensure that they do not play with the appliance.
* There shall be adequate ventilation of the room when the unit is used at the same time as appliance
burning gas or other fuels.
GROUNDING INSTRUCTIONS:
having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly
installed and grounded.
qualified electrician install an outlet near the appliance.
NOTICE:
NEVER CUT THE PLUG FROM THE ELECTRICAL CORD AND ALWAYS
ENSURE THE OUTLET IS GROUNDED. CUTTING THE CORD WILL VOID
THE WARRANTY.
2
CHARACTERISTICS
DIMENSIONS:
INSTALLATION & USE
Note 1:
prior to installation.
Note 2: At least two people will be required to mount this unit.
DESCRIPTION/CONNECTIONS:
* The unit may be installed in the ducted or ductless version.
3
outside.
3. Long duct runs, elbows, and transitions will reduce the performance of the ventilator. Use as few of
them as possible. Larger ducting may be required for best performance with longer duct runs.
4. It is recommended that a 6” round metal duct be used.
ELECTRICAL CONNECTIONS:
codes and standards.
TURN OFF ELECTRICAL POWER AT SERVICE ENTRANCE BEFORE WIRING
* If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
INSTALLATION:
1. Attach the duct outlet adapter to the top
of the ventilator with the four screws provided.
Tighten securely.
2. The ventilator is designed to be operated
4
DUCT INSTALLATION:
angle of bend 90o
as smooth as possible inside.
It is also advisable to aviod any drastic changes
Use fasteners to secure duct.
DUCTLESS INSTALLATION:
Ductless Con-
version Kit
3. Install the 6” round to 7” round transition
4. Connect 7” round duct to transition.
90o angle boot.
6. Locate center of 4-1/4” x 10” opening horizontal centerline of hood and at least 25”
above top of liner.
90o angle boot
FITTING UNDER SOFFIT OR CABINET:
There will need to be adequate room to run the 6”
power cable will run, since a hole might have to be made in the wall to accomodate it.
2. Unscrew the 2 visable screws located on the face plate of the ventilator unit, the eight mounting holes
around the perimeter of the unit are now accessible.
screws. Fit the face plate on the ventilator and secure using the 2 screws provided.
5
NOTICE:
buring gas or other fuels.
OPERATION:
This ventilator may be operated using the push button switch on the front panel.
The light switch turns the lamps on and off.
The fan switches turn the blower on to one of the selected speed settings.
MAINTENANCE
LAMP CONTROLS:
This ventilator may require two 50W GU10 halogen or two 3W GU10 LED lamps.
WARNING: Always switch off the electrical supply before carrying out any service on the appliance.
HALOGEN LAMPS OR LED GU10 BULBS:
To change bulbs:
1. Turn off unit and wait for lamps to cool down before removing.
CAUTION:
VENTILATOR CLEANING
appearance.
• Hot water with soap or detergent is all that is usually needed.
• For discolorations or deposits that persist, use a non-scratching household cleanser or stainless steel
polishing powder with a little water and a soft cloth.
• For stubborn cases use a plastic scouring pad or soft bristle brush together with a cleanser and water.
the surface.
• Do not allow deposits to remain for long periods of time.
• Do not use ordinary steel wool or steel brushes. Small bits of steel may adhere to the surface causing
rust to form.
• Do not allow salt solutions, disinfectants, bleaches, or cleaning compounds to remain in contact with
• Painted surfaces should be cleaned with warm water and mild detergent only.
6
1772 Airport Road
800-346-4042
WARRANTY
CASTLEWOOD by AMS, Inc. Ascension Ventilation ONE YEAR LIMITED WARRANTY
Castlewood by AMS warrants to the original consumer of this product that it will be free of defects in
OR MERCHANT ABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
During the one year period, Castlewood by AMS, Inc. will, at its discretion, repair or replace, without
charge, any product or part which is found to be defective under normal use and service.
normal maintenance and serivce, any products or parts which have been subject to misuse, negligence,
accident, improper maintenance or repair, faulty installation or installation contrary to recommended
installation instructions.
warranty. CASTLEWOOD by AMS, Inc’s OBLIGATION TO REPAIR OR REPLACE, AT IT’S DISCRETION,
by AMS, Inc. SHALL NOT BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES
ARISING OUT OF OR IN CONNECTION WITH PRODUCT USE OR PERFORMANCE. Some states do not allow
may not apply.
state to state. This warranty supersedes all prior warranties.
To qualify for warranty service, purchaser must notify Castlewood by AMS, Inc. at the address stated
nature of any defect in the product or part. At the time of requesting warranty service, purchaser must
present evidence of the original purchase date.
Submit claims to:
Table of contents
Other Ascension Ventilation Hood manuals
Popular Ventilation Hood manuals by other brands
Miele
Miele DA 5391 W Product dimensions
Wolf
Wolf PW302718(R) Planning information
Respekta
Respekta CH 21060 SBZ Installation & user's instructions
Zephyr
Zephyr AK2100AS Use, care and installation guide
Atag
Atag WS80 DM Series Instructions for use
Berbel
Berbel BLB 60 FL Operating and installation instructions
Lamona
Lamona LAM2500 User instructions
Cuppone
Cuppone Donatello KDN 435 PRE-INSTALLATION AND INSTALLATION MANUAL
Modena
Modena Fresco Series User manual book
ADC
ADC AD-30V installation manual
Zephyr Essentials
Zephyr Essentials Breeze I Use, care and installation guide
ROBLIN
ROBLIN WINDY PRO 900 Instructions for installation
