Ashford TREADLE KIT FOR TABLE LOOM STAND User manual

Ashford Guarantee
Thank you for purchasing this Ashford product. In the unlikely event there is
any fault in manufacture, please contact the dealer you purchased it from. To
validate the guarantee, please go to www.ashford.co.nz/product-registration
Ashford Handicrafts Limited
415 West Street, Ashburton 7700, New Zealand
Telephone [phone]
[e-mail] www.ashford.co.nz
INSTRUCTIONS
TREADLE KIT FOR TABLE LOOM STAND
400mm (16ins) 600mm (24ins) and 800mm (32ins)
TLTK070518V2

x2

x2
x4

Ashford Handicrafts Limited
415 West Street, Ashburton 7700, New Zealand
Telephone [phone]
[e-mail] www.ashford.co.nz
12-13cm (4¾-5¼")
Texsolv pegs set shaft rest position
Move the levers into the up
position on the 4 shaft or the
4 right hand levers on the
8 shaft loom. Insert Texsolv
pegs through the Texsolv
cord beside the cord guide as
illustrated. These pegs set the
height of the shafts in the rest
position.
NOTE: The shafts should be
between 12 - 13cm (4¾ -
5¼") from the underside of
the castle top.
Pull the Texsolv cord out of the
lever and castle front. Loop
the Texslov cord that attaches
to the treadles around the top
Texsolv cord and feed it down
through the appropriate cord
guide in the top of the castle.
Then feed this cord between
the corresponding shafts,
through the corresponding hole in the treadle and secure with a Texsolv peg. Adjust the position of the
peg until the treadle touches the ground just before the shaft touches the underside of the castle top.
x2x2x12 x4 x4
Real Scale Hardware List