AsiaRF AP7628-NN1 User manual

INSTRUCTIONS
As illustrated,
1､Place the device beside your existing wifi router, power it on.
2､Connect the two devices with the attached cable. Do pay attention
to plug one cable head into the WAN port of the new device, and the
other head to the LAN port of the existing router.
3､Find the wifi name and the password from the bottom label of the
new device, connect it, and enjoy your internet.
Configuration
1. Connect the Ethernet cable to the LAN port and your
notebook/computer.
2. Power up.
3. Open Internet Explorer from your notebook/computer
4. Enter: http://10.10.10.254
5. Enter the Username and Password. If this is the first time use,
than enter “admin”and “admin”on both username and
password.

Federal Communication Commission Interference
Statement
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for
help.
FCC Caution: Any changes or modifications not expressly
approved by the party responsible for compliance could void the
user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
IMPORTANT NOTE:
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 20cm between the
radiator & your body.
This transmitter must not be co-located or operating in conjunction
with any other antenna or transmitter.
Country Code selection feature to be disabled for products
marketed to the US/CANADA