Asko W6761 User manual

P1 P2 P3 P4
Menu Enter
Start
Stop
THE CONTROL PANEL
Model W6761 has ASKO’s state-of-the-art EasyControl™ panel, as illustrated below. To select a wash program, simply press one of the
preset program buttons then press Start. Refer to “Preset Programs” below for a definition of these programs.
DoorOpenButton
Press to open the
glass door.
Preset Programs
Press one of these buttons to
select a program.
LCD Window
Displays the wash program, spin speed,
temperature settings, and program run time.
Power Button
Press to turn on
power to the
machine.
Program Selection Controls
These buttons allow you to customize the preset program settings,
such as wash temperatures, spin speed, rinses, display language,
etc. Refer to the Use and Care Guide for instructions.
Power Indicator Light
Glows when the power
is turned on.
Start/Stop Button
Press to start or
stop a program.
Preset Programs
This model has four preset programs, as defined in the table below. To select a program, simply press one of the program buttons then press Start.
Preset Wash Spin # of Short Long
Program Wash Cycle Types of Laundry Temp (1) Speed (1) (2) Rinses Spin Spin
P1 Light wash Normally soiled loads 140° F 1600 rpm 5 2 yes
P2 Light wash Normally soiled perma press 105° F 1600 rpm 5 2 yes
P3 Quick wash Lightly soiled fabrics 105° F 1600 rpm 3 0 yes
P4 Hand wash Washable silks, nylon, etc. 85° F 800 rpm 3 1 no
NOTES: (1) You can temporarily adjust the temperature settings and spin speed. (See “Temporary Program Changes” below.)
(2) These are the maximum spin speed settings allowed for the program.
Temporary Program Changes
You can make temporary changes to the wash temperature and/or spin speed on the preset programs. Simply press the button for the preset
program you want to use then follow the instructions below. The settings will revert to normal at the end of the program.
Temperature – Press until the desired temperature displays in the LCD window. (The options are 85°, 105°, 120°, 140°, 160°, 175°, and
205°.) If you also want to change the spin speed, read the following paragraph, otherwise, press Start.
Spin Speed – Press until the desired spin speed displays in the LCD window then press Start. (The spin speeds advance in 200 rpm
increments.)
You can easily customize the preset programs to best fit your laundry needs. See “Customizing the Preset Programs” in your Use and Care Guide.
Power Button
The Power button turns the power to the machine on and off. When the power is on, the power indicator light glows red. The power must be
on before you can open the glass door, set the programs or start the machine.
Start/Stop Button
Once you’ve selected a program and options, press this button to start the washer. You also press this button to stop the washer during a
program. (See “Interrupting or Cancelling a Program” on the next page.)
Door Open Button
When the washer has completed a program, press this button to open the glass door. Please note that the power must be on and the washer
drained to open the door.
We know you’re excited about owning an ASKO washing machine and you’re anxious to get started, so here is a brief summary of the
operating procedures. To get the most of the features of your machine, we recommend that you read your Use and Care Guide.
Washer Quick Start Guide 9$%$

P1 Light wash
P2 Light wash
P3 Quick wash
P4 Hand wash
P1 P2 P3 P4 Start Stop 105˚ 43
rpm
1400
UNDERSTANDIN THE LCD WINDOW
The LCD window is easy to read and understand. It displays the wash program selection along with the wash temperature, spin speed, and
program run time. The illustration below explains what each item on the LCD window is.
rpm
Spin speed for the selected program.
Program Time
When you start a program, the total time
the program runs is displayed. As the
program progresses, the time remaining
displays. The program time toggles
between the hours (e.g., 1h) and the
minutes (e.g., 22).
Temperature
Wash temperature for the
selected program.
Stop
Indicates that the program has ended
or that you pressed Stop.
Start
Indicates that you pressed Start
and the program is running.
Preset Programs
Displays the program that
is selected/running.
Program
When you press the Power button,
the display toggles between the
program numbers and the wash
program names, (e.g., Normal,
Super quick, etc.)
Door Open
Displays when you press
the Door Open button.
THE DETER ENT DRAWER
The detergent drawer on ASKO washers automatically dispenses the detergent and
fabric softener at the appropriate times. The drawer is located to the left of the control
panel. Simply pull the drawer out and pour the measured amounts of detergent and
softener into the proper compartments (as illustrated) and close the drawer.
If you use liquid detergent, you will need to use the main wash compartment partition
packaged with your washer. (See your Use and Care Guide.)
DETER ENT AND FABRIC SOFTENER AMOUNTS
Because ASKO washers use less water than conventional top-loading washers, you need less detergent and fabric softener. We recommend
that you use a low-sudsing powder detergent only, preferably a high-efficiency (HE) detergent designed specifically for front-loading washers.
(Liquid detergents tend to suds more, which make them more difficult to rinse out.)
Detergent –The amount of detergent needed varies, depending on the detergent you use. For high-efficiency detergent specifically for
front-loading washers, you should use the amounts recommended by the manufacturer. For regular laundry detergent, 1 to 3 tablespoons of
detergent is all you need for a normal wash load. More heavily soiled items, however, may need slightly more detergent. Also, the amount
of detergent needed can vary due to differences in water hardness. (Refer to your Use and Care Guide for more details.) If you choose to use
a liquid detergent, start out with a very small amount, such as one or two tablespoons.
Fabric Softener –We recommend that you use only 2 tablespoons of fabric softener. If more softening is desired, try using slightly more
with the next load.
Prewash detergent
Main wash
detergent
Fabric
softener
Werecommendthatyoudon’tusebleach in your ASKO washer.
The tumbling wash action, temperature control options and
extended wash times are sufficient to remove most stains.
NOTE: The detergent drawer is equipped with an optional
child safety catch. (See your Use and Care Guide.)
Refer to your Use and Care Guide for additional programming and operational information as well as care and cleaning instructions.
QUICK START PROCEDURES
1.
2.
3.
4.
5.
6.
7.
Press the Power button to turn on the machine.
Press the Door Open button to open the inner door and load the wash. (The door will open in a few seconds.)
Check that the door is clear of laundry then close it firmly. (The door won’t shut if it’s slammed.)
Pour the detergent and fabric softener into the proper compartments in the detergent drawer, as illustrated below.
(Don’t put detergent in the prewash compartment unless you plan to prewash.)
Close the detergent drawer securely. (Do not slam it closed.)
Press the button for the desired program. If desired, change the temperature and/or spin speed.
Press Start. The machine will start.
9$%$
Art. no. 80 646 41 Rev. 02
Interrupting or Cancelling a Program
To interrupt a program to add an item, press and hold the Door Open button for about 3 seconds. The machine will stop and the water will
be pumped out before the door will open. Add the item to be washed and, if necessary, add more detergent. When you close the door, the unit
will start at the point it was interrupted.
To cancel a program, press and hold the Start/Stop button for a few seconds. You will have to reselect a program and press Start/Stop to
restart the machine. The program will start from the beginning.