ASL INTERCOM Dog Palace User manual

ASSEMBLY INSTRUCTIONS
STEP 1
Place floor panel on a
flat surface with round
STEP 3
Place roof on side
panels and slide
Hardware Included:
4 - 3” Cap Screws 4 - Hinged Screw Covers 4 - 2” Coated Deck Screws
flat surface with round
support rings facing
down.
Insert rear end panel
into
end opposite of drain
hole.
STEP 2
Insert side panels
into the floor and rear
end panel, front corner
first as illustrated.
panels and slide
into rear end panel
as illustrated.
STEP4
Insert 2 Cap Screws through
2 Screw Hinged Covers.
Screw the assembly through
one of the holes near the top
of the end panel and into the
roof with a Phillips
screwdriver (snug only) then
close Hinged Screw Cover.
Continued

Dog Palace
PREMIUM Insulated Dog
House
Assembly Instructions
Thank you for purchasing a Dog Palace
PREMIUM Insulated Dog House. We hope
that you and your dog will enjoy the many
premium features of this product. The Dog
Palace was designed with ease of assembly in
mind but should you have any questions
regarding assembly please call us at
STEP 5
Insert front end
panel assembly with
door into assembly into
floor as illustrated
(repeat Step 4
assembly instructions).
STEP 6
Screw 2 Coated Deck
Screws
into the 1/8”dia.
regarding assembly please call us at
1-618-455-3383. DO NOT RETURN THIS
PRODUCT TO THE STORE WHERE YOU
PURCHASED IT. We will be happy to assist
you with any questions or comments that you
might have regarding the Dog Palace.
212 S. Main Ste. Marie, IL
Tele: 618-455-3383 Fax:[phone]
Email: [email protected]
Manufactured in the USA by
Lifetime warranty against cracking or breaking.
Screws
into the 1/8”dia.
predrilled holes at
each end of the
floor with a Phillips
screwdriver. (Snug only -
do not overtighten)
1/8” dia. Hole
in front and rear
of base

NEW FEATURE HEATER
PORTAL
REMOVE INSIDE & OUTSIDE RED
CAP PLUGS WITH INSULATION PLACE HEATER IN BACK ½ OF HOUSE & RUN ELECTRICAL
CORD THRU HOLE IN PANEL
RESTING CORD IN BOTTOM PART
OF HOLE (HEATER SOLD
SEPERATELY)
REPLACE INSULATION IN PORT
HOLE AND INSTALL RED PLUGS BY
ROTATING 90 DEGREES TO CLOSE
HOLE FROM BOTH SIDES