Assa Abloy ED5202 Series User manual

Cylinder
Tailpiece
Cylinder Collar
Active Head Cover
Cylinder Housing
(2) Cylinder Screws
10-24 x 3/4" (19mm)
FM219 07/19
Installation Instructions
Copyright © 2003, 2018, 2019, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in
whole or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
For installation assistance contact Corbin Russwin
1-800-543-3658 • [e-mail]
WARNING
This product can expose you to lead
which is known to the state of California
to cause cancer and birth defects or other
reproductive harm. For more information
go to www.P65warnings.ca.gov.
IMPORTANT
For use in conjunction with
Corbin Russwin 955 Series trim.
(2) Cover Screws
8-32 x 1/4" (6mm)
ED5202(S) Series
Double Cylinder

Copyright © 2003, 2018, 2019, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
For installation assistance contact Corbin Russwin
1-800-543-3658 • [e-mail]
Corbin Russwin, Inc.
225 Episcopal Road
Berlin, CT 06037 USA
Phone: [phone]
Fax: [phone]
www.corbinrusswin.com
FM219 07/19
1 Cylinder Collar Chart
Cylinder Length Collar
1-1/8" (29mm) 270F15
1-1/4" (32mm) 654F07
1-1/2" (38mm) 654F08
2 Double Cylinder Trim Housing Installation (supplied with device)
Follow 955 Series trim installation instructions.
Substitute cylinder housing assembly with Double
Cylinder Trim Housing Assembly supplied with device.
(Figure 2) Continue with trim mounting instructions.
1. Follow ED5200(A) mounting instructions (supplied with
device). Once complete, continue with Double Cylinder
instructions below.
2. Pre-assemble cylinder through cylinder collar, active head
cover and cylinder housing as shown on the cover page.
Secure cylinder housing to cylinder with two (2)
10-24 x 3/4" cylinder screws. Keyway position should be vertical with
plug-in lower side of cylinder. (Figure 3)
3. Assemble active head cover to device by inserting cylinder tailpiece into lazy cam
slot of Double Cylinder Trim Housing Assembly. (Figure 2) Adjust tailpiece
length as needed to prevent interference with opposing trim cylinder. Install
and tighten two (2) 8-32 x 1/4" cover screws to active head cover.
4. Check for proper functional operation of trim and exit device.
Cylinder
Length
Figure1
Cam tip (this side)
Lazy Cam Slot
(2) Cylinder
Mounting Screws
Figure2
Figure3